Electrolux 5700 series Kullanıcı El Kitabı - Sayfa 12

Elektrikli Süpürge Electrolux 5700 series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Electrolux 5700 series 17 sayfaları. Household type

Electrolux 5700 series Kullanıcı El Kitabı

Brush Roll

The brush roll turns as it sweeps and combs the carpet nap.
Remove hair and threads from the brush roll so it continues
brushing the carpet. To maintain the most efficient cleaning,
the bristles must touch the carpet. To test the bristle length,
hold a ruler against the underneath side of the cleaner. If the
bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt, Code ZE090
The brush roll belt turns the brush roll to agitate, sweep, and
comb the carpet nap. Check the belt regularly to be sure it is in
good condition. Replace the belt if it stretches, cracks or loses
tension. Cut away any hair or threads wound around the brush
roll or the belt pulley because the buildup could cause the belt
to rotate unevenly.

How To Replace Brush Roll Belt

NOTE:
Turn off the switch and unplug the
electrical cord before replacing belt. Belt pulleys
can become hot during normal use. To prevent
injury, avoid touching the motor shaft when
changing the belt.
2
2
1. Lower handle to floor to change belt.
2. Remove three screws indicated by screwdrivers in
above illustration. Lift hood to remove.
NOTE:
The carpet height adjustment has to be in
the lowest or highest position to remove or reinstall
the hood.
3
3. Lift left end of brush roll.
4. Remove and discard belt.
12
1
2
4
Motor
Shaft
Belt
Brush
Roll
5. Place new belt around motor shaft.
7
6. Place belt around brush roll pulley.
7. Align left end cap with base. Push end cap securely
into place.
8. Pull right side of brush roll to stretch belt. Secure right
end cap into base.
IMPORTANT
Rotate brush roll by hand two full
9.
rotations to properly position belt.
10. Place hood back on cleaner. Make sure hood front
is behind furniture guard. Replace three screws.
11. Tighten screws.
Use GENUINE Electrolux replacement belt, Code
ZE090.
5
8
6
9