Electrolux Afuera Planlama ve Kurulum Kılavuzu - Sayfa 8

Elektrikli Süpürge Electrolux Afuera için çevrimiçi göz atın veya pdf Planlama ve Kurulum Kılavuzu indirin. Electrolux Afuera 10 sayfaları. Central cleaning system
Ayrıca Electrolux Afuera için: Kullanıcı El Kitabı (6 sayfalar)

Sayfayı Yazdır

STEP 3: Installation of Power Unit

The power unit is screwed to the wall with the

bottom screws of the mounting bracket located

48" (1.2m) up from the floor to allow convenient

removal of the dirt canister. For proper motor

cooling, there must be at least 12" (30.5cm)

between the unit and the ceiling.

If mounting on plaster or panel walls, be sure

mounting bolts enter studs.

If mounting on concrete wall, drill the wall with a

masonry bit and insert plastic or lead anchors.

As an alternate mounting on concrete walls, 2"

x 4" (5.1 x 10.16cm) studs or plywood may be

suspended from overhead.

With the power unit mounted, strip the low-volt-

age wire and crimp into the two "slip-on" termi-

nals provided. Connect main tube line to left

side of power unit, with connector and clamp

provided. Do not cement this connection to the

power unit in case you wish to remove at some

future date. Do not install power unit where the

ambient temperature exceeds 120 degrees

Fahrenheit (48.9 degrees C).

NOTE: For top-loading units, follow directions

provided with unit.

This unit may be exhausted to exterior to expel

fumes, germs, and some noise. Use the same

tubing and fittings as before. If vented, the

exhaust air should not be vented into a wall,

ceiling, or concealed

space of a building. Venting over 10 ft. (3m) is

not recommended.

NOTE: On/Off switch on power unit is for the

inlet on power unit only. All other inlets operate

automatically when the hose end is inserted into

the inlet valve or when the switch, which is

located on the hose handle, is turned on.

WIRING

Check local codes but use not less than #14-3

wire. Plug power unit cord into appropriate

120/220/230/ 240V - 50/60 cycle electrical out-

let. Be sure line voltage is sufficient to handle a

15 amp. load.