Electrolux Beam Kurulum Kılavuzu - Sayfa 9

Elektrikli Süpürge Electrolux Beam için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Electrolux Beam 16 sayfaları. Central

Sayfayı Yazdır

Wiring the Inlets & the Appliance

For picture clarity in the diagrams, we have only shown one cable with a blue and a

brown sleeved wire within it. However, as mentioned on page 14, if the inlet isn't

on the end of the run, then you will actually have two cables in a loop going to the

inlet. This is to ensure that there are no breaks in the wire, where you can't get to

them at a later date should a connection become loosened. This will mean both

blue sleeved wires will be fitted underneath the screw of one contact and both

brown tightened by the other. Make sure that the opposing colour wires do not

touch, as you will create a short and the appliance cannot be activated remotely.

WALL INLET: Slot cable through the special hole in the mounting

plate. Cut back the outer and the inner blue and brown sleevings

2cm from the end. Loosen the two screws on the contacts and

make sure each wire is twisted to create a solid contact. Wind 1

wire (2 if 2 cables) around each contact screw and tighten.

Attach to wall mounting plate using screws included. On metal

inlets use 4mm prong crimps to insulate wires from inlet.

VACPAN AUTOMATIC DUSTPAN: Do as above, cutting back the

sleeving. Loosen the two screws on the contacts towards the

back of the VacPan and wind one wire

contact screw and tighten again. Ensure that you have enough

length/ play in the cable to match the flexible pipe. This allows

the plinth of the kitchen unit to be removed if required. Details

of the size hole to cut in the plinth are included with the VacPan.

PERSONAL CLOTHES BRUSH: Placed permanently above a wall inlet

where the cable needs to run up to the clothes brush connector

instead of the inlet. Drill a hole large enough to accommodate the

cable on the surface the clothes brush is to be mounted. Cut back

the sleeving and twist the 2 wires

on the back of the assembly. Insulate them with electrical tape

and screw assembly to the permanent surface.

LOW VOLTAGE CABLE CONNECTION TO BEAM PLATINUM APPLIANCES:

Cut back the sleevings as mentioned above. Locate the speaker-

style low voltage terminals to the rear left-hand side of the

appliance. Hold-down the lever of each terminal and ensure that

each wire is inserted deep enough to be held firmly in place.

OR:

LOW VOLTAGE CABLE CONNECTION TO BEAM SPECIFIER APPLIANCE:

the low voltage terminals can be found to the rear left-hand side

of the appliance when it is mounted on the wall. Cut the tip of

the rubber boot with scissors, large enough to pass the cable

through. Cut back the sleevings as above. Crimp the terminals to

the stripped wires and push them into the appliance. Slide the

boot over the terminals onto the ring for a snug fit.

(2 if 2 cables)

(4 if 2 cables)

onto the 2 wires

around each