Atlantis Wireless Barcode Scanner Hızlı Başlangıç Kılavuzu - Sayfa 2

Barkod okuyucu Atlantis Wireless Barcode Scanner için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Atlantis Wireless Barcode Scanner 2 sayfaları. Barcode scanner

Sayfayı Yazdır
Before Getting Started
Open the package and check every accessory
Wireless Scanner
USB Receiver
USB docking station
USB recharge cable
About your Atlantis wireless scanner
KC-3200ZB is one on one wireless data communication
protocol. The scanner is already paired with the USB receiver. Just
easily plug USB receiver and start the operation. The
scanner on a real time basis, if the scanner is connected, the
barcode is decoded and transmitted to the remote host without
any delay. If the scanner is not connected or out of range, the data
is lost (status: 4 beeps)
Note:
New batteries should be fully charged before their first use
Wake up your Atlantis wireless
scanner
Press and release the trigger on your scanner to activate it.
Your scanner is ready to work when blue LED comes on.
Connect USB receiver to a host
computer
The device can be quickly recognized by host computer
without any software/driver installation. Within less than
10 seconds the receiver will double flash blue to inform the
Initialization is completed.

Recharging the battery

The Red LED comes on when the battery level is low, please
recharge the scanner immediately. When the scanner is
charging, the LED is green (solid). A full recharge (from
completely drained battery) takes approximately 4 hours.
When the scanner is fully charged, the green LED will go off.
Scanner LED indicator
Status / indicator
Beeper
Blue LED
Green LED
Red LED
Good Scan
1 beep
1 blink
Transmission
4 beeps
failure
Low battery
Recharge
On
Operation mode
On
Sleeping
None
None
None
Noe
USB receiver LED indicator
Color
Indication
Red
LED will flash to present the success of transmision
Default setting of wireless scanner
The default setting of wireless scanner is 2425MHz and
power saving with 10min period of time. The default values
can be modified by re-pairing the scanner and USB receiver.
The setting switch and pairing button are located at USB
receiver as shown
Setting switch 1 is associated with
volume of beeper
Volume of beep
#1
Low
ON
High
OFF
Setting switch 2 is associated with
frequency
Frequency
#2
2480MHz
ON
OFF
2425MHz
On
Setting switch 3 & 4 is associated
with power management
Power saving (sleep mode)
#3
#4
switch off after 10min.of inactivity
OFF
OFF
Scanner is always on
ON
ON
ON
OFF
switch off after 30min.of inactivity
OFF
ON
switch off after 1min. of in activity
Note: Before configure the switch setting, please first remove the
USB receiver from host computer.
How to pair your scanner and
receiver?
Scanner
Press and hold the trigger for 10 sec. release the
1
trigger after hearing 1 beep
In 1 second
Piease quick press the trigger for 10 times
2
within five (5) sec. in order to put the scanner in
pairing mode.
In 5 second
The scanner will beep every second when stay in
3
paring mode (for about 45 seconds.)
In 2 second
USB receiver
Press and hold the pairing button for 10 sec.
4
release the button after seeing red LED flashing.
In 1 second
Please quick press the pair bottom for 10 times
5
within five (5) sec.in order to put the scanner in
pairing mode.
In second
in pair mode, the USB receiver will blink every
6
second (for 25 xeconds)
** When devices are successfully paired you will hear beeps three
times from scanner and see three bllnks from USB receiver.