Atlas AA-SMG Kurulum Talimatları

Amplifikatör Atlas AA-SMG için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Atlas AA-SMG 4 sayfaları. Atlas sound sound masking module installation instruction

Sayfayı Yazdır

AA-SMG

SOUND MASKING MODULE

AA-SMG INSTRUCTIONS

Thank you for purchasing the Atlas Sound AA-SMG masking module. Please read this instruction sheet

carefully prior to use to assure a clear understanding of the ﬂexibility the AA120M and AA-SMG offers you.

Prior to using any Atlas Sound module please read the AA120M manual prior to use. It is very important for

one to know the difference between Amp Direct and Mix Bus modes.

KEY FEATURES

1. Gain Trim – When the gain is set to max (Clockwise), it is designed that the 70v output will not exceed

30v. When fully attenuated the module will have a 1v or less at the 70v outputs

2. EQ Trim– The EQ ﬁlter operating range is between 1 KHz and 8 kHz with a slope of 6db per octave.

When the potentiometer is rotated fully clockwise the variable Hi-Cut ﬁlter is at 8 kHz.

3. EQ Insert – This TRS insert jack allows you to use an external equalizer for ﬁne tuning of the system.

Tip = Send to the EQ, Ring = Return from the EQ and Sleeve is the ground.

4. Line Out – This feature allows you use the generator to send a signal to another ampliﬁer for

multizone masking. You have the selection of two signal pick up points, Pre EQ or Post EQ. The Pre

EQ is a ﬁxed level of 250mv. The Gain, EQ or Insert jack have no effect on the Line Output. If Post EQ

is selected, the Line Out signal is affected by the Gain level, EQ setting and the Insert Jack. In Post

EQ mode the Line Out signal is the same signal that the AA120M is receiving.

5. Post or Pre EQ (jumper J11) – This is for the Line Out jack signal. To select this function, prior to

inserting the module into the ampliﬁer, locate (jumper J11) header and place the jumper to the desired

selection. Note: You only need to move the jumper one pin over for connection. The middle pin is

always connected.

6. Pink and White Noise selection (jumper J5)- Reposition the jumper for desired signal type. The

middle pin is always connected.

7. Amp Direct and Mixed Bus (jumper J10) – This selection determines the master gain feeding the

ampliﬁer. It also works in conjunction with Input 6 module selection switch position 5 located on the

rear panel of the AA120M. We suggest when using the AA-SMG module, the amp and module and

AA120M are set to the Amp Direct position. The middle pin is always connected.

8. Out to Amp (jumper J8) – If you do not want the AA-SMG signal to go to the AA-120M and want to

use the module to feed an external ampliﬁer set this jumper to the OFF position.

1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •

Specifications are subject to change without notice

AtlasSound.com

Printed in U.S.A.

INSTALLATION INSTRUCTIONS

TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435

ATS002745 RevA 3/07