Atlas DPA-102PM Kullanıcı El Kitabı - Sayfa 11
Amplifikatör Atlas DPA-102PM için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Atlas DPA-102PM 20 sayfaları. Networkable 2-channel power amplifier with dsp
Sayfayı Yazdır
Owner's Manual
Accessing the Web Browser GUI Control Panel
DPA amplifiers include a unique set of features and configurations. All DPA amplifiers are configured from the factory out of the box to
operate as traditional commercial power amplifiers. Ethernet connectivity is not required for operation of a DPA amplifier. However, to
take full advantage of the DSP settings such as, EQ, hi & lo Cut filters, level control / assignment and limiter settings, the DPA Control
Panel must be accessed via the network or local computer. External software is not required to operate the DPA amplifier; the software
is embedded onto the amplifier in what is called the web browser GUI Control Panel interface. To access the onboard control panel,
follow one of the five methods listed below.
Accessing the GUI Control Panel
I.
Direct Connection via Ethernet
II. Internet Web Browser via a Network
III. Atlas Sound IP Discovery Software
IV. Smartphone or Tablet
V. Accessing the DPA via the Internet Outside the Local Network
Note: The GUI was designed to be standardized for all DPA 2 and 4 channel models. For 2 Channel models some of the faders /
controls that refer to CH 3 & 4 will be disabled.
I. Direct Connection via Ethernet
Use this method if there is no network access available.
1. Connect an Ethernet cable from the laptop or desktop computer to the Ethernet Input on the DPA amplifier. Most computers
will allow direct connection from the DPA amplifier using a standard CAT5 cable. Some older computers may require the use of
a Crossover (Patch) cable to connect to the DPA amplifier. If a connection cannot be made using a CAT5 cable, use a Crossover
cable.
2. Turn OFF the computer's Wi-Fi.
3. Open a web browser on the computer, Google Chrome and Mozilla Firefox are the recommended browsers for use with DPA
amplifiers.
4. This example uses the DPA amplifier model DPA-102PM.
In the Web Browser address bar, type in the following: (http://dpa102pm) and hit enter. See example in Figure 1.
5. Out of the box all that is needed to connect / communicate to the amplifier is the amplifier's model number and it is not case
sensitive. Note: After connecting to the amplifier, the name of the amplifier can be changed to meet the install's naming
requirements. As an example at a school the amp may be renamed "ROOM1". After the name is changed, follow the same
process to log onto the amp as outlined above, but change the name from "http://dpa102pm" to "http://room1".
6. The amplifier will be discovered and the DPA Control Page will launch after pressing the "Enter" key.
An example of the DPA Control Page GUI web page is shown in Figure 2.
7. The DPA amplifier's IP address can be directly entered into the Web Browser to access the DPA GUI.
Example: "http://192.168.1.110".
DPA-102PM - Networkable 2-Channel
Power Amplifier with DSP
Figure 1
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
– 11 –
Specifications are subject to change without notice.
AtlasSound.com