Atlas TSD-PA252G Kullanıcı El Kitabı - Sayfa 4

Amplifikatör Atlas TSD-PA252G için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Atlas TSD-PA252G 8 sayfaları. 2x25w global audio amplifier
Ayrıca Atlas TSD-PA252G için: Kullanıcı El Kitabı (8 sayfalar)

Sayfayı Yazdır

2x25W Global Audio Amplifier

Rear Panel Description

TSD Input/Output connections are removable for easy system wiring. The connectors have a 3.5mm

pitch between pins.

1. DC Power Input - Each TSD that requires DC power comes with a 2 position c onnector for an

external 24VDC power supply (sold separately). Because of the TSDs low power consumption, a

single external power supply may power more than one TSD. Please refer to the specifications

on current requirements in milliamps to match with the appropriate power supply. Please observe

the polarity of the wiring to this connector. Note: It is acceptable to exceed the current

requirements of the TSDs but NOT safe to use a power supply that is below the current

requirement of the device. When using an 8Ω speaker load, use a power supply with 1000mA

capacity. For 4Ω speaker loads, use a power supply with at least 2000mA capacity

(Atlas TSD-PS24V2500MA).

2. Balanced Line Inputs L & R - Connect balanced line level signals to these left and right phoenix

style connectors. Your connection must be mated properly to the input connector or signal loss

and/or noise may occur. Note: Unbalanced line level inputs can also be used by connecting the

(G) and (-) terminals together.

3. RCA Inputs L & R - Unbalanced audio signals applied to these female RCA connectors are

controlled from the front panel L & R control knobs.

4. Speaker Outputs L & R - Connect the loudspeaker wiring to these terminals, observing the polarity

shown on the rear of the chassis. When in stereo mode, a polarity reversal on one channel will

cause poor bass response and low output levels. In Bridged Mode, connect the 8Ω speaker

load across the left speaker output (+) terminal and the right (+) speaker output terminal. The Left

speaker output terminal is positive (+) in Bridged configuration. Note: The Bridge Mode speaker

wiring configuration differs from other Atlas Sound TSDs. Check each model's manual for specific

wiring instructions.

5. Cable Management Retainer Points - Use the rear panel screws for connecting the included cable

retainers. Each TSD comes with two cable retainers for simplified cable management.

TSD-PA252G

Owner's Manual