AirTechnic AIRZONE UNO Kurulum Kılavuzu - Sayfa 2

Kontrol Paneli AirTechnic AIRZONE UNO için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. AirTechnic AIRZONE UNO 5 sayfaları.

Sayfayı Yazdır

ΑIRTECHNIC

Blue Cable:

To clamp Y of the receiver with the Y of the control panel.

Black Cable

: To clamp "-" of the receiver with the "-" of the control panel.

Brown Cable:

To clamp W of the receiver with the W of the control panel.

Red Cable:

To clamp "+ " of the receiver with the "+ " of the control panel.

Green Cable:

To clamp V of the receiver with the V of the control panel.

Yellow Cable:

To clamp I of the receiver with the I of the control panel.

Airzone Tacto

Airzone Plus

To install an Airzone Tacto Thermostat or an Airzone Plus Thermostat, carefully open the

thermostat by pushing the flap on the bottom of it and separate both parts of the thermostat.

Extract the cable through the cable duct at the bottom and fix the rear part to the wall with

screws.

Plus or Tacto thermostats are connected with A type Airzone Cable in the following way:

Blue Cable:

To clamp Y of the receiver with the Y of the control panel.

Black Cable

: To clamp "-" of the receiver with the "-" of the control panel.

Brown Cable:

To clamp W of the receiver with the W of the control panel.

Red Cable:

To clamp "+ " of the receiver with the "+ " of the control panel.

Green Cable:

To clamp V of the receiver with the V of the control panel.

Yellow Cable:

To clamp I of the receiver with the I of the control panel.

Important:

Control cabling should run through a separate duct from that of the power cables and, in any

case, the meshes of the type A cables will be connected to the earth in the electronic control

panel. I f standard Airzone cable is not used, a shielded cable should be used with a cross-

section no lower than 0,22mm2.

Airzone offers a 3-year guarantee for its systems if Airzone cable is used.

4. MOTORIZED DISTRIBUTION ELEMENTS

Airzone I ntelligent Grille

Grill + Motorized Hatch

With the electronic Control Panel Airzone Type-B two-color cable will be used for connection

or, if not, a cable with a 0,75mm2 cross-section, to the corresponding M outlet, with the

following polarity:

Red Cable:

From clamp "-" of the control panel to clamp "-" of the grille.

Black Cable

: From clamp "+ " of the control panel to clamp "+ " of the grille.

Special conditions for connecting motorized distribution:

Zone with Two Motorized Grills: 2 motorized grills may be connected to the same Control

Panel.

Cordless Zone with Two Motorized Grills: Only one of the motorized elements may have the

Cordless receiver fitted. The other distribution element will be connected in parallel, and it

will not have an integrated receiver.

Check that the system is correctly connected: Pay particular attention to the 12V direct

current inlet. When the direct electrical current is connected, the control panel is reset,

switching the red led on for 4 seconds and activating closure of the motors.

INTELLIGENT AIR-CONDITIONING

AIRZONE UNO – INSTALLATION MANUAL

Page 2