Bose 131 Kullanıcı El Kitabı - Sayfa 4

Konuşmacılar Bose 131 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose 131 18 sayfaları. Marine loudspeaker system
Ayrıca Bose 131 için: Kullanıcı El Kitabı (37 sayfalar), Kullanıcı El Kitabı (23 sayfalar), Servis Kılavuzu (7 sayfalar), Servis Kılavuzu (7 sayfalar), Manuel (7 sayfalar)

Sayfayı Yazdır

Setting Up

Unpack the carton

Figure 1

Packaging Contents:

• Two 131 marine speaker

enclosures

• Two mounting flanges

• Two speaker grilles

• One Owner's Guide

• One template for

positioning, cutting, and

drilling holes

• Two speaker cone shields

• Mounting hardware:

• 30 screws (6 extra)

• 10 wire nut connectors

(2 extra)

• Two 20 foot speaker

cables, 18-gauge

Tools required

Carefully unpack your speakers and save all packing materials for possible future use. Do not

attempt to use your speaker system if any part of it appears damaged. Notify Bose

tion or your authorized Bose dealer immediately. Check that your system contains the parts

identified in Figure 1. For shipping, the mounting flange is packed inside its speaker grille.

Separate these components before installation.

Notes: Please remove the perforated drilling and cutting template from the inner carton

containing the grille and mounting flange. Also remove the perforated speaker cone shields

from the inner cartons containing the enclosures. You will need the template and shields

during installation.

Now is a good time to record each speaker serial number on page 2 of this guide and on

your warranty card.

CAUTION: The 131

marine speakers are not intended to be installed in automobiles.

You will need the following tools to complete this installation:

• Phillips-head screwdriver.

• An appropriate cutting tool for the surface to be cut. For installation in fiberglass or wood,

we recommend a sabre saw. Use a short blade, and have some extra blades available. A

hole saw may also be used. Large diameter hole saws are available and they allow you to

make circular cuts on a flat surface.

• Drill with the following bits:

- For drilling the screw holes a

⁄

(.32 cm) inch bit.

- For drilling the starter hole, use a

• Center punch or awl.

• Half-round file or rasp.

• Eye and ear protection; dust mask.

CAUTION: Failure to follow these instructions voids all warranties on your speakers. If you

are unsure of your ability to complete this process, consult a professional installer. Please

read this owner's guide completely before beginning installation.

October 30, 2001

⁄

inch (.24 cm) bit is preferred, but you could also use a

⁄

inch (.8 cm) bit.

Corpora-

AM188201_02_V.pdf