Bose 201 Series IV Kullanıcı El Kitabı - Sayfa 7

Konuşmacılar Bose 201 Series IV için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose 201 Series IV 13 sayfaları. Direct/reflecting speakers
Ayrıca Bose 201 Series IV için: Kullanıcı El Kitabı (13 sayfalar), Kullanıcı El Kitabı (12 sayfalar)

Sayfayı Yazdır

Check the connections

Check that all connections are made positive to positive (+ to +) and negative to negative

(– to –) (Figure 5). Make sure that no loose strands of wire touch across terminals. This

could damage your receiver or amplifier. Be sure the connections are secure before you

plug in the receiver or amplifier and turn it on.

Back of right speaker

Test the speakers

To make sure your speakers operate correctly:

1. Place the speakers less than 6 inches (15 cm) apart, facing each other.

2. Turn on your receiver, and set it to MONO (monophonic), if that is an option on your

model.

3. Set the balance control to normal (center position).

4. Play some deep bass passages of music through the speakers.

The sound should seem to come from a point between the two speakers. The bass should

be full and natural. If it is not, one of the connections may be reversed, causing the speak-

ers to play out of phase. Refer to "Make the connections" on page 6. To correct the

problem, make sure all the wires are connected positive to positive (+ to +) and negative to

negative (– to –). Then repeat steps 1 through 4 to re-test the speakers.

L +R?? Rich Y.

AM183562_04_V.pdf

– +

–

Receiver or Amplifier

October 30, 2001

Back of left speaker

Setting Up

Figure 5

Completed connections