Bose 901 Kullanıcı El Kitabı - Sayfa 9

Konuşmacılar Bose 901 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose 901 23 sayfaları. Vi direct/reflecting speaker system
Ayrıca Bose 901 için: Kullanıcı El Kitabı (41 sayfalar), Montaj ve Montaj Talimatları (1 sayfalar), Kullanıcı El Kitabı (12 sayfalar), Kurulum ve Kullanım Kılavuzu (15 sayfalar), Kullanıcı El Kitabı (20 sayfalar)

Figure 4

Connecting the speakers to the

receiver

Equalizer Connections

AM195438_03_V.pdf

Checking the speaker connections

Make sure the terminal knurled nut is tightened down firmly. Any gap between the wire and

terminal can cause heat build up. Check to be sure the wires are connected positive to

positive (+ to +) and negative to negative (- to -). Make sure no loose strands of wire touch

across terminals, which can cause short circuits.

There are two options for connecting the equalizer. Your choice depends on the type of

receiver you own and whether you plan to use the system primarily for stereo or for home

theater enjoyment.

Stereo/non-home theater use

(tape monitor connections)

The Bose

901

active equalizer connects directly to your receiver through the tape monitor

connection. If your receiver has more than one tape connection, use the second one (TAPE 2).

To connect a tape deck, use the additional set of inputs and outputs located on the back of

the 901 active equalizer marked TAPE RECORDER CONNECTIONS.

The TAPE MONITOR switch on the front of the receiver lets you switch the equalizer in and

out of the signal path. This is important when you want to play conventional, non-equalized

speakers or headphones attached to your receiver. See Using other equipment on page 13.

Note: If your receiver is designed for home theater use, it may not have a Tape Monitor

switch. If not, you must use a PRE AMP OUT/MAIN AMP IN connection. This may also be

called the ADAPTER or SIGNAL PROCESSOR connection. Refer to "Home theater use (PRE

AMP OUT/MAIN AMP IN)" on page 10 for instructions on how to connect for home theater

use.

1. Disconnect any external tape deck or signal processor connected to the tape monitor

connection.

2. Use the twin cable assemblies (with two connectors at each end) that are supplied with the

equalizer. Use the red connector for the right (R) channel connections and the other

connector for the left (L) channel connections.

November 21, 2001

Setting Up

Receiver

+ –