Bose FreeSpace DS 100SE Servis Kılavuzu - Sayfa 16

Konuşmacılar Bose FreeSpace DS 100SE için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Bose FreeSpace DS 100SE 21 sayfaları. With ceiling mount bracket
Ayrıca Bose FreeSpace DS 100SE için: Kullanıcı El Kitabı (32 sayfalar), Kurulum Kılavuzu (17 sayfalar), Teknik Veri Sayfası (8 sayfalar), Kurulum Kılavuzu (22 sayfalar), Tasarım Kılavuzu (4 sayfalar)

Sayfayı Yazdır

1. Freespace Ds 100Se Surface-Mount Loudspeaker

DISASSEMBLY PROCEDURES

5. Rear Enclosure Removal

5.1 Perform procedure 1.

5.2 Using a Phillips-head screwdriver, re-

move the five screws (22) located around the

perimeter of the loudspeaker's front baffle.

Remove the one screw (22) located on the

side of the rear enclosure near the woofer.

Slide off the rear enclosure.

6. Crossover PCB Removal

6.1 Using a Phillips-head screwdriver, re-

move the five screws (22) located around the

perimeter of the loudspeaker's front baffle.

Remove the one screw (22) located on the

side of the rear enclosure near the woofer.

6.2 Disconnect the two Faston connectors

from the woofer terminal strip (14). Discon-

nect the two Faston connectors from the P1

and P2 pins on the crossover PCB (9).

6.3 Perform procedure 1.

6.4 Using a Phillips-head screwdriver, re-

move the four screws (24) that secure the

tweeter to the front baffle (8). Lift out the

tweeter. Disconnect the two Faston connec-

tors from the tweeter terminals. Remove the

foam batting and feed the wires out through

the hole in the tweeter enclosure.

6.5 Remove the four screws that

secure the crossover PCB assembly to the

enclosure. Lift off the PCB assembly.

7. TAP Rotary Switch Removal

7.1 Perform procedure 5.

7.2 Using a small flat-tip screwdriver, gently

pry underneath the TAP switch knob (5) to

remove it. Take care to not mark the enclo-

sure or baffle.

7.3 Using a nut driver, remove the nut that

secures the switch (10) to the baffle. Slide

the switch out of the baffle.

8. Audio Transformer Removal

8.1 Perform procedure 7.

8.2 Make a note of the wiring configuration

of the transformer harness wiring connec-

tions. Unplug the two Faston connectors

from the crossover board at P1 and P2.

Unplug the three Faston connectors from

the terminal board located on the rear

enclosure.

8.3 Remove the four screws (24) that

secure the audio transformer (12) to the

enclosure. Lift out the transformer.