Atlas Copco Secoroc 7655 Operatör El Kitabı - Sayfa 10
Matkap Atlas Copco Secoroc 7655 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Atlas Copco Secoroc 7655 20 sayfaları. Pusher leg rock drill
Sayfayı Yazdır
Trigger
When the trigger (A) is pushed in, the feed force stops abruptly and the setting
on the feed control lever is overridden. The piston rod in the pusher leg retracts
automatically. This function is used for example to adjust the height of the rock
drill, when rigging up the pusher leg, or when there is a tendency to jam. When the
trigger is released, the feed control setting is activated again.
Oil regulating valve
Oil dosing is controlled using a screwdriver. Tighten the nut after regulation.
Check that sufficient lubrication is obtained by putting your hand in front of the
exhaust port while adjusting the regulating valve. If the hand is covered by a thin
film of oil after a few seconds, the lubricator has been correctly adjusted. Too much
oil will have negative effects on the operation whilst too little will result in damage
to parts as the temperature rises during operation.
The amount of oil going into the rock drill increases when turning the valve counter
clockwise, and it decreases when turning the valve clockwise. Oil consumption is
2.5–6 ml/minute.
10