Atlas Copco Secoroc YSP Series Operatör Talimatları/Yedek Parça Listesi - Sayfa 13
Matkap Atlas Copco Secoroc YSP Series için çevrimiçi göz atın veya pdf Operatör Talimatları/Yedek Parça Listesi indirin. Atlas Copco Secoroc YSP Series 20 sayfaları. Rock drill
Sayfayı Yazdır
Problem
Cause
Uneven
The side bolts are unevenly
running
or insufficiently tightened.
(continued)
Can cause the various parts
to lose their alignment,
resulting in the seizure
of the movable parts.
Abnormal strains on the
side bolt may result in
fracture at the threads.
The drill gets
Lack of oil
hot
Freezing
High level of humidity in the
compressed air
Water pressure higher than
the air pressure
Water pipe
Misalignment of the shank
breakage
Damaged flushing hole in
the shank
Chipping of the
Misalignment of the shank
piston tip
Excessive wear of the
piston tip
Spline breakage Lack of lubrication
Dirt intrusion (specially
when drilling upwards)
Piston breakage Lack of lubrication
Uneven tension in the side
bolts
Worn guide sleeve/piston
guide (can be confirmed by
the cushion test)
Side bolt
Uneven tension on the bolts Tighten the bolts correctly
breakage
Solution
Check and repair any damage to
the contact points and tighten the
bolts with the correct tightening
torque
Add oil and check that it runs
through. It is not sufficient that
there is oil in the exhaust air.
There must also be an oil coating
on the shank of the drill steel.
Use water traps
Lower the water pressure
Change drill steel or shank sleeve
or both
Change drill steel
Change the drill steel or shank
sleeve or both
Change piston
Lower the water pressure if it is
the same as or greater than the
air pressure
Increase lubrication or change oil
Increase service intervals
Lower the water pressure if it is
the same as or greater than the
air pressure
Increase lubrication or change oil
Tighten the bolts correctly
Change the worn part
13