Bose 101 Series II Kullanıcı El Kitabı

Hoparlör Sistemi Bose 101 Series II için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose 101 Series II 2 sayfaları. Fpo music monitor speaker system
Ayrıca Bose 101 Series II için: Kullanıcı El Kitabı (2 sayfalar)

Sayfayı Yazdır

Right Speaker

– +

• •

– +

Receiver or Amplifier

Figure 1

Connect the wire from the positive (red) terminal on each speaker to the

corresponding positive terminal on your receiver. Similarly, connect the

wire from the negative (black) terminal on each speaker to the negative

terminal on your receiver.

Figure 2

Connect a speaker cord to each 101

speaker by depressing the tabs and inserting

the bare ends of the wires. Connect the posi-

tive wire to the red terminal and the negative

wire to the black terminal.

Phasing Test

To make sure that your speakers are connected to your receiver in phase (positive

to positive and negative to negative) perform this simple test:

1. Set your receiver or amplifier to MONO if that is an option. Set the balance

control to the middle (normal) position.

2. Temporarily place the loudspeakers so they are facing each other at close

range.

3. Play some deep bass passages of music through the speakers. The sound

should seem to come from a point directly between the speakers, with full, rich

bass.

4. If the music seems to be lacking in deep bass, reverse the + and – connec-

tions on one speaker and repeat the test. Use the connection which produces the

most powerful bass.

Using the Speakers with a TV

To use your 101 Series II speakers in an audio/video system, be sure to place the

speakers at least nine inches from the television monitor. This prevents interfer-

ence with the picture quality.

Left Speaker

– +

• •

– +

Series II

Maintenance

To clean your speakers, turn off your receiver or amplifier. Then, simply wipe with

a damp cloth. Be sure to keep moisture away from the speaker terminals.

Warranty

The Bose

101

Series II Music Monitor

five year warranty.

In Case of Difficulty

If your 101 Series II speaker system exhibits any of the following problems, try the

suggested solutions before returning it for service.

Problem

Reason/Solution

Only one speaker plays.

One speaker wire is improperly connected. Check

the wires and connections. See Figure 2.

Adjust the balance control on your receiver or

amplifier.

Neither speaker plays.

Your receiver or amplifier is set for operation with

headphones only. Reset your receiver or amplifier.

The tape monitor switch on your receiver or ampli-

fier is in the on or tape position. Reset the tape

monitor switch.

Weak bass.

Speakers may be out of phase. Perform the

"Phasing Test" and reconnect them.

If you are still having trouble with your speakers, please contact Bose at 1-800-

367-4008 to verify any defect and arrange for service. Bose Corporation will make

every effort to remedy any problem within the terms of the warranty.

Accessories

To make your Bose 101 Series II speaker system even more flexible and fun, the

following accessories are available from your Bose dealer, or directly from Bose

Corporation. For information call 1-800-444-2673 between 8:30 am and 9:00 pm

eastern time.

Accessory

Description

101 Wall Bracket

Mounts your 101 Series II

speaker on a wall or other surface.

101 Travel Bag

Transports two 101 Series II

speakers from place to place,

easily and safely.

speaker system is covered by a limited

Model

Part Number

WB-10

125384

TB-2

134899