Bose 301 Series IV Kullanıcı El Kitabı - Sayfa 6

Hoparlör Sistemi Bose 301 Series IV için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose 301 Series IV 12 sayfaları. Direct/reflecting speakers
Ayrıca Bose 301 Series IV için: Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (13 sayfalar), Servis Kılavuzu (12 sayfalar)

Sayfayı Yazdır

Choose

the cord

It is important to use the proper gauge (thickness) of speaker cord. Standard zip cord

(2-conductor, 18-gauge wire) works for most applications. You can find this wire at most

electrical and hardware stores.

You will need thicker wire if your speakers will be more than 30 feet (9 m) from a receiver (or

amplifier). Refer to the wire recommendations

under "Technical information" on page 10, or

contact your authorized Bose _ dealer for more information.

Note: Before running speaker cord through a waft or under a floor, check your local

building code requirements and safety regulations. You may want to contact an electrical

installer for this information.

CAUTION:

Never use broken or frayed

wiring, which can result in

electrical shock or damage.

Prepare

the cord

Speaker cord consists of two insulated wires. The insulation around one wire is marked

(striped, collared, or ribbed). This marked wire is always positive (+). The plain wire is always

negative (-). These wires correspond to the red (+) and black (-) terminals on the speakers

and the receiver.

At the ends of each cord, strip approximately 1/2inch (12 mm) of insulation from both wires.

Twist the bare end of each wire so loose strands will not touch across terminals. Be sure to

connect each wire to the proper terminal (positive to positive and negative to negative).

Note: It is sometimes difficult to distinguish wire markings. Inspect both wires carefully.

Make

the connections

Just press the terminal tab on the back of each speaker to insert the appropriate wire

(Figure 3).

1. Connect one speaker cord to your right speaker.

a. Attach the marked wire at one end to the red (+) terminal.

b. Attach the plain wire at that end to the black (-) terminal.

2. Connect the other end of the same cord to the RIGHT SPEAKER OUTPUT of your

receiver.

a. Attach the marked wire to the red (+) terminal.

b. Attach the plain wire to the black (-) terminal.

3. Connect the second cord to the left speaker and LEFT SPEAKER OUTPUT. Follow the

steps in 1 and 2 above.

CAUTION:

Before maktng any connec-

tions, turn off your receiver

and unplug it from the AC

power (mains) outlet. Not

doing so may result in dam-

age to your system.

Red terminal tab

Figure

How to make terminal connec-

tions

Marked

October 30, 2001

AM181869_04_ Vpdf