23zero Dakota 2200 Kullanıcı Kılavuzu - Sayfa 7

Çadır 23zero Dakota 2200 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 23zero Dakota 2200 14 sayfaları. Roof top tent

ROOF TOP TENT USER MANUAL

Attaching mounting rails

Remove the roof top tent from the carton and place on a clean surface. Observe the face of the

baseboard which has four holes in the centre area of the base, face this side upwards. Open the

tent and remove contents from inside.

Once you have determined the orientation of your roof top tent and mounting rails, prepare the

mounting rails by sliding 2 x M6 Nyloc nuts and lining them up with each hole in each rail. Using

the four supplied 40mm Steel M6 bolt with 50mm M6 washers, slide your hand inside the tent

between the base and mattress, and insert the bolts with washers into the pre-drilled holes. The

bolt threads should be facing outward. Place mounting channels on exposed bolts and hand

tighten once located into the Nyloc nut.

Once all bolts and nuts have located, tighten firmly from inside the tent using the supplied 10mm

spanner.

Note: If you chose an orientation which requires you to fit the mounting rails along the 1200mm

edge of the baseboard, these will extend 100mm past each edge. Cut these flush with the edge

of the baseboard.

Note: DO NOT DRILL HOLES INTO THE BASEBOARD.

If the pre-drilled holes do not work with your set up, contact [email protected]

Now that the mounting rails have been fitted, turn the roof top tent around allowing 2 pairs of

holes on the outer edge of the baseboard to face upward, (4 pairs of holes for the Dakota 2200).

Using the 40mm M6 bolts and 1 washer per bolt, insert these through the holes via the inside of

the tent. With the bolt threads facing outward, locate the holes on the ladder brackets and place

these over the bolt threads. Add the second washer and twist Nyloc nut hand tight. Once all

located, tighten all nuts with 10mm spanner.

Line up the holes on the ladder with the holes on the ladder brackets and insert the 2 x 16mm

M6 bolts ensuring a nylon washer is placed between the ladder and the ladder bracket. Once all

Nyloc nuts are located, tighten with 10mm spanner.