Replacing the remote control batteries
Figure 16
Opening the remote con-
trol battery compartment
Troubleshooting
Problem
System doesn't do any-
thing
No sound
AM259776_01_V.pdf
Slide the battery compartment door off of the back of the remote. Find the polarity markings
(+ and –) inside the compartment and install the batteries accordingly. Slide the cover back on
the remote and snap it closed.
AAA batteries (4)
compartment
What to do
• Make sure the power connector is inserted securely into the media center, the power
cord is inserted securely into the Acoustimass
cord are plugged fully into operating AC wall outlets.
• Be sure to select a source (CD/DVD, AM/FM, etc.).
• Unplug the media center power supply for 60 seconds, then reconnect it. This allows the
unit to reset itself after a power surge or power interruption.
• Increase the volume.
• Check to see if MUTE is lit on the display. If it is, press the Mute button on the remote
control to unmute the sound.
• Make sure the audio input cable is firmly seated in the media center SPEAKER ZONE 1
jack and the multi-pin connector on the other end is firmly seated in the Acoustimass
module AUDIO INPUT jack.
• Check speaker connections.
• Turn the media center off for 60 seconds, then on again, to restore communication
between the media center and the speakers.
• Check the connections for any external components. Make sure to select the correct
source for the desired input.
• Be sure the disc is placed correctly, label-side up, in the CD tray.
• Connect the FM and AM antennas.
• Make sure that the power switch on the Acoustimass module is set to ON (I).
October 30, 2001
+
+
+
+
Battery
compartment
Battery
door
®
module, and the power pack and power
Reference
37
Sayfayı Yazdır