ABSCO SHEDS ADGAZEBO63 Manuel - Sayfa 11

Dış Mekan Mobilyaları ABSCO SHEDS ADGAZEBO63 için çevrimiçi göz atın veya pdf Manuel indirin. ABSCO SHEDS ADGAZEBO63 14 sayfaları. Signature gazebo

GUTTERING

Absco Industries

Assembly Instruction Manual

ABSCO SIGNATURE GAZEBO

MODEL: ADGAZEBO63

6.12m W x 3.11m D x 2.60m H

0. Remove protective plastic coating from

guttering components.

1. Next join both lengths of gutter RWG24, to

match the overall finished length of the structure.

Notch out the rolled edges (shown in grey) to

allow one to slide inside the other.

Consider which way you want the water to fall

before notching. Make sure the 'uphill' gutter is

notched and inside the other.

2. Put silicone in the joint and then use two rivets

FAST102 per side.

3. Take a gutter end stop RWG25 and test fit it

over an end of the gutter. Mark off the following.

A. Midpoint along the top

B. Face of gutter shown

4. Trim away area shown in grey with tinsnips

5. Repeat steps at the other end to make the

other end stop.

6. Attach end caps with a rivet FAST102 through

the front back and bottom. Joints may be sealed

using silicone.

7. Test fit the assembly

• Front and rear flashings go inside end caps.

• Roof panel 'top skin' sits under top face of

end caps.

• This face will be against the low side beam.

Model: ADGAZEBO63

4/12/23

1.00