Bose Companion 3 Series II Kullanıcı El Kitabı - Sayfa 12

Stereo sistemi Bose Companion 3 Series II için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose Companion 3 Series II 40 sayfaları. Multimedia speaker system
Ayrıca Bose Companion 3 Series II için: Kullanıcı El Kitabı (40 sayfalar), Kullanıcı El Kitabı (22 sayfalar), Kullanıcı El Kitabı (10 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (26 sayfalar), Hızlı Kurulum Kılavuzu (2 sayfalar), Hızlı Kurulum Kılavuzu (2 sayfalar), Detaylı Montaj Talimatları (2 sayfalar), Kurulum Kılavuzu (20 sayfalar), Teknik Özellikler (6 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Kullanıcı El Kitabı (19 sayfalar), Servis Kılavuzu (36 sayfalar), Servis Kılavuzu (16 sayfalar)

System Setup

Making connections

Figure 6

Making connections

Labeled jacks on the rear of the Acoustimass

the system permit fast and easy hookup (Figure 6).

CAUTION: Do not plug the Acoustimass module into an AC power (mains) outlet until all the

source components are connected to the module.

Right speaker

• Speakers to the Acoustimass module; Plug each speaker connector into the corresponding

"L" or "R" jack marked "To Satellite", on the rear of the module.

• Control pod to the Acoustimass module; Plug the control pod cable into the jack marked

"Control Pod", on the rear of the Acoustimass module.

• Sound source to the Acoustimass module; Connect one end of the audio input cable to the

input from the computer jack

your computer's audio output jack.

Note: If your computer only has two phono jacks, instead of a stereo mini jack, you will need

an audio adapter cable. Connect the audio input cable from your module to the adapter cable.

Then insert the ends of the adapter cable into your computer's stereo phono jacks.

1. Insert the small connector end of the power cord into the AC INPUT jack on the module.

2. Insert the large end of the cord into an AC power (mains) outlet.

3. Turn the power switch, located on the back of the Acoustimass module, to ON (|).

The LED on the control pod will light up yellow indicating standby mode.

To connect an additional sound source:

To connect an external CD or MP3 player to your system, plug the cable from the sound

source output jack into the input jack on the control pod. See Figure 7 on page 11.

To connect headphones:

Insert the headphone connector into the headphone jack

Note: Connecting headphones will silence the output from your speakers.

module and the custom cables supplied with

Bass compensation

To Satellites

Input from

computer

To Control pod

on your Acoustimass module. Connect the other end to

on the control pod.

Left speaker