Bose Acoustic Wave music system II. Kullanıcı El Kitabı - Sayfa 17

Medya Dönüştürücü Bose Acoustic Wave music system II. için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose Acoustic Wave music system II. 28 sayfaları. Owner's guide
Ayrıca Bose Acoustic Wave music system II. için: Kullanıcı El Kitabı (30 sayfalar), Kullanıcı El Kitabı (30 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı Kılavuzu (25 sayfalar), Kullanıcı El Kitabı (13 sayfalar), Kullanıcı El Kitabı (6 sayfalar), Kullanıcı El Kitabı (2 sayfalar), Hızlı Kurulum Kılavuzu (2 sayfalar), Kullanıcı El Kitabı (30 sayfalar), Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (29 sayfalar), Kullanıcı El Kitabı (29 sayfalar), Kullanıcı El Kitabı (30 sayfalar)

Figure 10

Inserting headset plug

into the connector

Figure 11

Location of headphone

and microphone

receptacles in a typical

plane's control panel

Using the Bose

Installed DC power connector

An optional installed connector is available for pilots who want to use

their plane's DC power, instead of the battery pack, with the portable

adapter cable. The connector's small size allows it to be installed in a

convenient location in the control panel, for example, near the head-

phone and mic jacks.

Installing the DC power connector

Note: This installation must be done by mechanics qualified to

perform this type of avionics installation for the aircraft in which the

installed connector will be used.

1. Install the wires from the DC power connector into the plane.

The pinout for the connector is as follows:

Pin Wire

Description

Red

Headset power (7-32 Volts DC). Use a .5 amp fuse or

circuit breaker.

Black

System ground. Connect to the existing audio ground.

2. Plug the headset adapter power plug into the connector.

3. Insert the headphone and microphone plugs into their receptacles

in the aircraft's control panel.

Aviation Headset