Bose FreeSpace E4 Series II Kullanıcı El Kitabı - Sayfa 11
Amplifikatör Bose FreeSpace E4 Series II için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose FreeSpace E4 Series II 33 sayfaları. Business music system
Ayrıca Bose FreeSpace E4 Series II için: Kullanıcı El Kitabı (18 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Kullanıcı El Kitabı (16 sayfalar), Kullanıcı El Kitabı (15 sayfalar)
Sayfayı Yazdır
5.5.1 Setting the clock
The date and time of the hardware clock is initially set in Eastern
Standard Time. After your PC is connected to the hardware,
check the clock and set it as necessary for the time zone and
region of your installation.
To adjust the clock settings manually, click the Set Clock button
in the clock panel. The Clock Settings window opens, allowing
you to make adjustments to the date and time. Click Apply or OK
to set the clock in the hardware, or click Cancel to close the win-
dow and leave the clock settings unchanged.
5.5.2 Adding events
When you click the On/Off, Volume, Source, or Auto Volume
event button, an event of that type is added to the event list. At
this point you can change the event settings. When the event list
exceeds the length of the pane, the software will add a scroll bar
on the right side.
A maximum of 64 events may be added to a system. This means
that the total number of events from all event lists must not
exceed 64. An On-Off event consumes two events, while source
change, volume change, and Auto Volume events consume one
apiece. A counter is provided in the Schedule mode window to
keep track of the number of remaining events.
Remaining events
counter
Zone events programmed to occur at the same time as a "Sys-
tem ON" event will not occur. To ensure that zone events will hap-
pen, they must be programmed to occur 15 minutes after the
"System ON" event. For example, if a "System ON" event is pro-
grammed to occur at 8:00 AM, the first zone event should be pro-
grammed to occur at 8:15 AM.
Installer's Note: Flashing the Installer software configura-
tion file to the E4 unit sets the default state of the system
when it is turned on. Whenever possible the default state of
the system should be set to meet the requirements most likely
to occur after a scheduled "System ON" event.
5.0 Using FreeSpace
Installer™ Software
®
This event applies only to the whole system. You can select indi-
vidual on or off times for the day(s) you choose. Or, you can
select on and off times in a single statement.
Programmer's Note: One Auto On/Off event specifies
both an "On" time and an "Off" time and is counted as two
events.
This event allows you to mute/unmute the zone output at a
specified time on selected days of the week.
This event allows you to change the volume level at a specified
time on selected days of the week.
Programmer's Note: The maximum/minimum volume
stops cannot be adjusted in this pane. To adjust these limit
stops, select the Output Gain function in the Set Up Hard-
ware mode.
41 of 80
Adds a system Auto On/Off event
Adds a zone Mute event
Adds a zone Volume Change event