Bose Lifestyle 35 Kurulum Kılavuzu - Sayfa 11
Amplifikatör Bose Lifestyle 35 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Bose Lifestyle 35 32 sayfaları. Dvd home entertainment systems
Ayrıca Bose Lifestyle 35 için: Kullanım Kılavuzu (48 sayfalar), Kullanıcı El Kitabı (22 sayfalar), Kullanım Kılavuzu (46 sayfalar), Kullanım Kılavuzu (44 sayfalar), Kullanım Kılavuzu (34 sayfalar)
Connecting the speakers to the Acoustimass
Figure 7
A two-wire connection type
speaker
3
3
Note: Before you start making system connections, make sure that the media center, the
Acoustimass module, and any additional equipment are not connected to AC power.
The five dual-cube speakers that come with your system will either have a two-wire cable
connector (Figure 7) or a plug-in cable connector (Figure 8 on page 12). Identify your type of
speaker and then follow the corresponding instructions.
Note: To lengthen the speaker cables, use heavy-duty RCA extension cables, or splice in 18-
gauge or thicker cord (connecting + to + and – to –). To purchase extension cables, see your
dealer or electronics store, or call Bose
included with your system.
Making a two-wire speaker connection
In a two-wire connection (Figure 7), the wire marked with a red collar is positive (+) and the
plain one is negative (–). These wires match the positive (red) and negative (black) terminals
on the back of each speaker.
Note: The surround speaker cables are joined together for your convenience, providing an
easy-to-use cable for connecting the surround speakers. To run the cables in different direc-
tions from the Acoustimass module, simply pull apart the cables as needed.
1. Match the correct cable to the corresponding speaker location. Front speaker cables
have blue connectors at one end, with L (left), R (right), or C (center) molded into the con-
nectors. The red collars on the + wire are labeled LEFT, RIGHT, and CENTER. Surround
speaker cables have orange connectors at one end, with L (left) or R (right) molded into
the connectors. The red collars on the + wire are labeled LEFT and RIGHT.
2. Connect the wire end of one speaker cable to the terminals on the rear of the matching
speaker. Press the terminal tab on the back of the speaker and insert the marked wire (+)
into the red terminal and the plain wire ( – ) into the black terminal. Release the tab to
secure the wire. Repeat this step for each of the five speakers.
3. Connect each cable to the corresponding jack on the Acoustimass module (Figure 9on
page 12). Plug the blue connectors into the matching left front, center, and right front
jacks. Plug the orange connectors into the matching left surround and right surround
jacks.
AM259777_02_V.pdf • April 23, 2002
System Installation Instructions
®
module
®
customer service. Refer to the Bose address list
Terminal tab
Red (+) wire
11