Bose PackLite Kullanıcı El Kitabı - Sayfa 6
Amplifikatör Bose PackLite için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose PackLite 15 sayfaları. Power amplifier
Sayfayı Yazdır
Svenska
Nederlands
P
L
TM
P
ACK
ITE
OWER
The connector panel
The A1 connector panel includes the features described in
Figure 2.
Figure 2
A1 connector
panel
AC power connector: Accommodates the supplied AC power cord to
1
connect your amplifier to the appropriate AC (mains) outlet. Check the
product label of your amplifier for the voltage rating: 120V or 230V.
Power switch: In the ON (l) position, applies power to your amplifier. When
2
ON, the power indicator (Figure 3) should be BLUE.
OUTPUT connector: Accommodates both 2- and 4-wire Neutrik
3
connectors.
OUTPUT can be connected to any of the following:
• B1 bass module.
• 4-ohm loudspeaker with a power rating of at least 250W RMS.
• 8-ohm loudspeaker with a power rating of at least 125W RMS.
INPUT connector: Accommodates a
4
plug.
INPUT can be connected to either of the following:
• Bass-Line OUT jack on the PS1 power stand using the supplied
¼"
TRS cable.
• THRU connector of an "upstream" A1 amplifier when used in series.
• Other line-level source output using either a
THRU connector: Accommodates a
5
sending the INPUT signal to another A1 amplifier.
Note:
could damage any interconnected equipment. Use THRU only as
an output to another A1 amplifier.
Note:
(balanced or unbalanced) present at the INPUT connector.
6
Italiano
Français
A
M
A1
MPLIFIER
ODEL
1
2
Do not use the THRU connector as a second input, as it
The THRU connector will only relay the type of input
Español
Deutsch
3
4
¼"
TRS (balanced) or TS (unbalanced)
¼"
TRS or TS cable.
¼"
TRS or TS connection. Used for
Dansk
English
5
®
Speakon
®