Drolet 5135 ML Manuel - Sayfa 9

Odun sobası Drolet 5135 ML için çevrimiçi göz atın veya pdf Manuel indirin. Drolet 5135 ML 16 sayfaları.

Couplings

Once the woodstove is placed in the room in accordance with required clearances,

it must be coupled to the chimney with a smoke exhaust system.

Verify the

clearance between your stovepipe and the surrounding combustible surfaces. If

the normal 18-inch (457 mm) clearance required cannot be obtained, you may use

an insulated flue pipe or a thermal protection shield.

Read and respect

manufacturer's instructions before installation.

Coupling pipes and chimney

must have the same diameter as

the stove outlet. If this is not the

case, contact your supplier in

order to insure there will be no

problem with the draught. Pipes

should be made of aluminized or

ordinary steel with a minimum 24

gauge thickness.

Your smoke evacuation system (pipes) should be assembled in such a way that

the male section of the pipes faces down. Attach each of the sections to one

another with three equidistant metal screws. The pipes must be short and straight.

All sections installed horizontally must slope at least 1/4 inch per foot, with the

lower section toward the stove.

To insure a good draught, the total length of the coupling pipe should never exceed 10

feet (3.04 m). (Except for cases of vertical installation, (cathedral-roof style) where the

smoke exhaust system can be much longer and connected without problem to the

chimney of the ceiling of the room). There should never be more than one 90° elbow in

the smoke exhaust system.

Installation of a "barometric draught stabilizer" (fireplace register) on a smoke exhaust

system is prohibited. Furthermore, installation of a draught damper is not recommended.

Indeed, with a controlled combustion woodstove, the draught is regulated upon intake of

the combustion air in the stove and not at the exhaust.

The connecting pipe must not go through ceiling, storage area, floor or any other

combustible partition.