247Blinds Plantation Shutter Montaj Talimatları Kılavuzu - Sayfa 6
İç Mekan Mobilyaları 247Blinds Plantation Shutter için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. 247Blinds Plantation Shutter 7 sayfaları.
Sayfayı Yazdır9) Now begin to drill each of the marked screw holes. Place
your wall plugs in, and bring the frame back, packing back in
the same position as before. The drill holes should now all
align.
10) Screw the frame securely into the wall and replace the panels as before, securing with the
hinge pins. Should you need to, use the hinge packers
supplied to make fine adjustments to the space between
the closed panels. You can also adjust the panels position
vertically.
11) Now fully secure your hinges by tightening the screws and
putting the final middle locking hinge screw in. For a clean
finish, place caps into the drilled holes onto the frame.
12) Using your decorators caulk, seal any gaps around the frame. You may also want to caulk
the inside of the back of the frame. Afterwards, use a wet wipe to finish.
You may find over time that your slats lose some tension. Not to worry, this can be adjusted by
using the slat tension screws, which are located on the inside edge of the panels. A quarter turn of
the screw is enough to tighten to mechanism.
247blinds.co.uk
Reviewed 06/12/2021
Next Review: 06/12/2023
To close the vanes, push the tilt rod upwards. Then,
applying light pressure, run your hand upwards
from
the bottom to fully close them. When closing the
panels, support the weight of the leading door,
lift up slightly and place back into the frame.