Drolet HUNTER DB00400 Kullanıcı El Kitabı - Sayfa 6

Setüstü Ocak Drolet HUNTER DB00400 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Drolet HUNTER DB00400 11 sayfaları. Wood heater and cook stove

Sayfayı Yazdır

Operating your HUNTER

Avoiding overheating :

Your HUNTER does not come with refractory firebrick. Nevertheless, it is recommended

(although not an obligation) to install firebrick on the bottom of the firebox. Even if the

firebrick does not fit perfectly on the bottom, leaving spaces between each brick, it will help

protect your firebox and increase its useful life.

Solid Fuel:

Your stove is designed to burn wood only; no other combustible should be burnt. Waste and

other flammable material should not be burnt in your stove. Any type of wood may be used

in your stove, but specific species have better energy yields than others. The vast majority

of the problems related to the operation of a wood stove are caused by the fact that the

wood used is too damp. These problems can be:

Ignition problems;

Creosote build-up causing chimney fires;

Low energy yield;

Incomplete log combustion.

Before your first fire:

Make sure that the chimney and flue pipe are well installed according to the

manufacturer's specifications.

Respect all clearances to combustible material and floor protection requirements

mentioned in this manual.

Ignition:

After making sure that the stove air intake control is fully open, place several rumpled sheets

of paper in the center of the combustion chamber. Place 8 to 10 pieces of small dry kindling

wood over the paper in the form of a tent. You may also place a few pieces of heating wood,

but choose them as little as possible. No chemical liquid (or accelerant) should be used

to light the fire.