DROMEAS Alma HC Kullanım Talimatları Kılavuzu - Sayfa 10
İç Mekan Mobilyaları DROMEAS Alma HC için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. DROMEAS Alma HC 12 sayfaları. Working desk
Ayrıca DROMEAS Alma HC için: Kullanım Talimatları Kılavuzu (17 sayfalar)
Sayfayı Yazdır3.5.6 Adjusting the surface's transition to the default memory location (for memory
handset - optional equipment)
1. Press the "DOWN" button on the Handset until the base reaches its lowest position.
2. Press and hold the "DOWN" button again until the LED display reads "RST".
3. Press and hold the "1" button (about 5 seconds) while the LED flashes "RST" and then
switches to either:
10.1 = Adjust to the default memory location with One-Touch
10.2 = Adjust to the default memory location with Constant-Touch
4. Choose one of the above positions and release the button "1".
5. Press and hold "1" button again until the desired setting is reached. Once the chosen
setting is displayed, release the button and wait about 5 seconds for the display to
return to "RST".
6. Finish the reset process by pressing and holding the "DOWN" button until the desk
lowers a little bit more, slightly rises and stops. Release the button. The new setting is
saved, and your desk is now ready to use.
3.5.7 Selection for sensitivity and anti-collision level (for handset controller-optional
equipment)
1. Press the "DOWN" button on the Handset until the base reaches its lowest position
2. Press and hold the "DOWN" button again until the LED display reads "RST".
3. Press and hold the "UP" button (about 5 seconds) while the LED flashes "RST" and
then switches to either:
10.5 = 10 kg. pressure (most sensitive)
10.6 = 15 kg pressure (middle setting)
10.7 = 20 kg pressure (least sensitive)
4. Choose one of the above sensitivity levels and release the "UP" button.
5. Press and hold the "UP" button again until the desired setting is reached. Once the
chosen setting is displayed, release the button and wait about 5 seconds for the
display to return to "RST".
6. Finish the reset process by pressing and holding the DOWN button until the desk
lowers a little bit more, slightly rises and stops. Release the button. The new anti-
collision sensitivity setting is saved, and your desk is now ready to use.
3.6 Collision tracking
The Alma HT/HC desk is equipped with a modern collision detection system. Thanks to the
advanced protection system, even the smallest office disturbance is recorded when moving up
and down. As a result, the movement of the surface is interrupted immediately when
obstructed and immediately moves towards the opposite direction. This ensures reliable
collision detection and maximum safety when moving the desktop.
WARNING: Risk of injury and damage!