Dromex DHFFM Hızlı Başlangıç Kılavuzu - Sayfa 2
Solunum Ürünleri Dromex DHFFM için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dromex DHFFM 2 sayfaları. Full face mask respirator
Sayfayı Yazdır
Fitting your Full Face Mask
• Visually inspect the mask for any tears or damage, ensuring all
components is in place and secure.
• Connect filtering cartridges to face piece
• Fully extend all head straps prior use.
• Centre the face mask onto your face by placing your chin and nose in the
chin and nose cup simultaneously whilst placing the extended harness
over your head
• Adjust harness straps, by first pulling the neck straps, towards the shape
of your head followed by temple straps and head strap
• Never pull harness straps away from the shape of your head as harness
straps can result in damage, rendering mask un-usable.
• Once tighten securely, conduct negative and positive pressure seal checks
of the masks
Mask leak tests
Negative pressure:
- Cover inhalation filters with the palm of your hand, inhale and hold your
breath for 5 seconds.
- The facepiece will collapse and remain collapsed against the face.
- Remove hand and breathe normally.
- If the facepiece did not remain collapsed during the test, or any leakage is
noticed, readjust straps and perform Negative Pressure Seal Test again.
Positive pressure check:
- Place palm of your hand over the exhalation valve and exhale.
The face piece should not leak around the face seal
- Maintain positive pressure for at least 5 seconds
a) If no outward leakage is detected, the test has been passed.
b) If leakage is detected (usually felt as a cool sensation against the
skin or as a loss of pressure hold), either the respirator is
malfunctioning or a gross leak exists between the face and face
piece
Removal of your mask
- Push harness buckles forward to loosen and fully extend the
harness straps.
- Insert thumbs under the bottom harness strap to pull face mask up
and away from face.
Materials
No.
DESCRIPTION
NO.
DX1
Harness
DX11
DX2
Full face sealing
DX12
DX3
Clear visor
DX13
DX4
Metal buckle
DX14
DX5
Adjustable clip
DX15
DX6
Full mask frame-top
DX16
DX7
Full mask frame-base
DX17
DX8
M4 stainless steel support-side valve
DX18
DX9
M4 cupper nut
DX19
DX10
Inhalation valve
Marking
Each mask is marked as indicated below:
DH-FFM DX-02
S~L
DX-06
EN 136:1998 CL1
Dromex: Unit 1, 1 Blase Road, New Germany, 3620, South Africa
T. +27(31) 713 1960 E. [email protected]
www.dromex.co.za
DESCRIPTION.
Face cup value support-side valve
Mask body
Valve seal ring-front
Exhalation valve support front
Exhalation valve diaphragm
Exhalation valve cover-front
Valve seal ring-side
Inhalation valve support-side valve
Inhalation valve diaphragm