Dromida DIDC0047 Hızlı Başlangıç Kılavuzu - Sayfa 3

Motorlu Oyuncak Araba Dromida DIDC0047 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dromida DIDC0047 4 sayfaları. Truck

DRIVING THE VEHICLE
1. Install the battery into the vehicle and
connect the ba t tery.
2. Secure battery strap to post using clips.
Brake/
Reverse
Forward
Neutral
• To slowly drive forward, pull the trigger slightly. To drive faster,
pull the trigger further .
• To brake, push the trigger. To drive in reverse, push again.
• During a crash, release the trigger .
• When the vehicle battery becomes low, the vehicle will start to slow down.
• Allow the battery to cool before recharging.
• Make sure to turn both the vehic le and the radio off after each use.
• ALWAYS unplug the battery after each use.
TRIMS AND DUAL RATES
Throttle Dual Rate
• If you need to limit the maximum speed of your vehicle, rotate the "TH.D/R" knob
counterc lockwise. For higher top speeds, rotate the knob clockwise.
Steering Dual Rate
• If you need to limit the amount of steering your vehic
counterc lockwise. For more steering, rotate the knob clockwise.
NOTE: We recommend limiting the vehicle's maximum speed for beginners and gradually
increasing the top speed once you become more comfortable with the controls.
DRIVING TIPS
• Always release the throttle trigger right away following a crash to prevent damaging the electronics.
• The vehicle should be operated in an open space with no people or animals nearby.
• Do not operate this vehicle on the street.
3. Switch radio on.
Forward
Reverse
• To turn, rotate the wheel to the left or right.
• Adjust the steering trim if the car doesn't track straight (see
Throttle Trim
• If the vehicle drives forward without throttle input, rotate the throttle trim knob slightly left.
• If the vehic l e drives backwards without throttle input,
Steering Trim
• If the vehicle tracks right (when viewed from behind), rotate the steering trim knob slightly left.
• If the vehic l e tracks left (when viewed from behind), rotate the steering trim knob slightly right.
• Check that the servo saver screw is fully tightened to ensure that your vehicle tracks straight.
le has, rotate the "ST.D/R" knob
4. Switch vehicle on.
Left
Right
Left
below).
rotate the throttle trim knob slightly right.
Right