Dromida DT4.18 BL Montaj ve Bakım Kılavuzu - Sayfa 11

Motorlu Oyuncak Araba Dromida DT4.18 BL için çevrimiçi göz atın veya pdf Montaj ve Bakım Kılavuzu indirin. Dromida DT4.18 BL 13 sayfaları.

PROGRAMMING

Running Mode: This function adjusts the running mode between forward/brake and forward/brake/reverse.

Drag Brake Force: This function adjusts the amount of drag brake applied at neutral throttle to simulate a slight

braking effect of a neutral brushed motor while coasting.

Low Voltage Cut-Off (LVC): This program is used to prevent the LiPo battery from over-discharging. The ESC

monitors the battery's voltage. At any time, if the battery's voltage is lower than the designated value, the output

power will be reduced to 50%. After 10 seconds the ESC will cut the motor power off.

Start Mode (Punch): This function adjusts the amount of initial power when the trigger is applied.

Maximum Brake Force: This program adjusts the amount of overall brake force applied when at full brake.

During programming the ESC the motor will emit a "beep" tone at the same time the LED flashes. A long time

flash and long "beep" represents "5" so it is easy to identify items with large numbers.

For example:

A long time flash (motor sounds "beeeep") equals a value of 5.

A long time flash + 1 short flash (motor sounds "beeeep-beep") equals a value of 6.

A long time flash + 2 short flashes (motor sounds "beeeep-beep-beep") equals a value of 7.

TO COMPLETE PROGRAMMING, SWITCH OFF THE ESC, AND THEN SWITCH IT ON