Dromida kodo hd Kullanıcı Kılavuzu - Sayfa 4
Dronlar Dromida kodo hd için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dromida kodo hd 4 sayfaları.
Sayfayı Yazdır
•
Do not attempt to charge a battery if it is swollen or hot.
•
Do not place the charger or any battery on a flammable surface or near
combustible materials while in use.
•
Always disconnect the battery and remove the charger from the USB port
when not in use.
•
Land your model immediately when the LEDs flash to indicate that the battery
power is low. Recharge the battery before attempting another flight. A dangerous
situation can occur when attempting to recharge an over-discharged battery!
•
Never disassemble or modify pack wiring in any way or puncture cells.
•
ALWAYS keep a supply of sand accessible when charging. Dumping sand on
the battery will extinguish a LiPo chemical fire.
•
Never charge inside a vehicle.
•
ALWAYS KEEP OUT OF REACH OF CHILDREN
•
Do not dispose of battery into fire or heat.
•
Do not use or leave battery near a heat source, such as
fire or a heater.
•
Do not strike, pierce or throw against a hard surface.
•
Do not disassemble or alter battery.
•
Turn off power switch and disconnect the battery after use.
FCC STATEMENT AND INDUSTRY CANADA NOTICE
1. This device complies with Part 15 of the FCC Rules and RSS-210 of Industry
Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Remark: This device is in accordance with the digital device grade B limitation and
the 15th regulation of FCC. This limitation requires reasonable anti-interference
protection around the residence. The device can transmit radio waves during
use and can interrupt the mobile communication without proper installment.
REPLACEMENT PARTS
2
4
3
®
© 2016 Dromida, a Hobbico
company
5
6
™
Interruption will occur for special device. If the device does interrupt the radio or
television, please turn the device off and then turn it on to adjust. Below are some
resolutions for your reference:
• Move the receiving antenna
• Enlarge the distance between the device and receiver
• Try to not connect the device and the receiver on the same circuit
• Ask for professional help from experts
3. This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus set out in the Radio Interference Regulations of
Industry Canada.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR
TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
90-DAY LIMITED WARRANTY
PLEASE DO NOT RETURN YOUR PRODUCT TO THE STORE. Dromida will repair
or replace factory defects for 90 days from the date of purchase. This warranty
specifically does not cover crash damage, misuse or abuse. To make a warranty
claim, please contact our product support team at 1-217-398-8970 ext #5 or
e-mail us at [email protected].
If requested by Product Support, please send defective product to:
Hobby Services
3002 N Apollo Dr., Suite #1
Champaign, IL 61822
Please include a note about the problem, your contact information, and a copy of
the receipt.
This warranty applies only if the product is operated in compliance with the
instructions and warnings provided with each model. Dromida assumes no liability
except for the exclusive remedy or repair of parts as specified above. Dromida
shall not be liable for consequential or incidental damages. Some states do not
allow the exclusion of consequential or incidental damages so the above exclusion
may not apply to you. This warranty gives you specific legal rights and you may
also have other rights which vary from state to state.
1
dromida.com
1
Part
Key
No.
No.
Description
DIDE1552
1 Rotor Blade Set
Black & Yellow (4)
2
DIDE1553
2 Blade Guard Set (4)
DIDE1554
3 Upper Body
3 Lens Housing top
3 Lens Housing bottom
7
3 Lens frame
DIDE1555
4 Frame
DIDE1556
5 Motor CW L/F R/R (2)
DIDE1557
6 Motor CCW R/F L/R (2)
DIDM1558 7 Control board
7 Dampers
6
DIDZ1559
8 Camera board
DIDZ1559
8 Lens
DIDE1550
9 Battery
5
DIDE1551
Transmitter
DIDE1511
USB Charger
9
DIDZ1501
Card reader
8
DIDE0006 v2