Elegoo MARS 4 Series Kullanıcı Kılavuzu - Sayfa 8

3D Yazıcılar Elegoo MARS 4 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Elegoo MARS 4 Series 20 sayfaları.
Ayrıca Elegoo MARS 4 Series için: Kullanıcı Kılavuzu (20 sayfalar)

Sayfayı Yazdır

5. Since the distance between the printing platform and the tempered glass will

change during the process of tightening the build platform screws, if you ﬁnd that the

MARS 4 DLP leveling paper can be pulled out without resistance, please click the

"down" button (in steps of 0.1mm) until there is slight resistance to pull out the

leveling paper.

(See Picture 4)

MARS 4 DLP leveling paper, please click the "up" button (in steps of 0.1mm) until the

leveling paper can be pulled out with slight resistance.

6. After completing the above leveling, set the current Z-axis position as the initial

height of the ﬁrst layer of printing. Operate as follows: return to the previous

interface, and click "Set Z=0". At this time, a message will pop up on the touch screen,

(as shown in Picture

works in print ﬁle mode.)

If there is too much resistance to pull out the

(Picture 4)

6). Then click "Conﬁrm" to complete. (Note: "Set Z=0" only

(See Picture 5)

(Picture 5)

此步骤将影响Z零点位置，是否继续？

(Picture 6)