Elegoo MARS 4 Series Kullanıcı Kılavuzu - Sayfa 17
3D Yazıcılar Elegoo MARS 4 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Elegoo MARS 4 Series 20 sayfaları.
Ayrıca Elegoo MARS 4 Series için: Kullanıcı Kılavuzu (20 sayfalar)
Sayfayı Yazdır
Machine Maintenance
Please do not use sharp or pointy tools to scrape the resin tank to avoid damaging the release
liner film.
Please clean up the resin tank before changing the resin to another color.
Before and after printing, clean the build plate with paper towels or alcohol to ensure that there
are no bumps or burrs on the build plate.
Before each printing, daily check the exterior of the machine and all mechanical parts for any
obvious damage, defects, or abnormalities.
Try to keep the printing environment at 25-30 degrees Celsius when printing, and ventilate the
printing room as much as possible to facilitate heat dissipation of the machine and resin odor
volatilization.
If the Z-axis keeps making friction noise, please add some lubricant to the lead screw. Please
check and apply lubricant grease at least every 2-3 months, and increase the frequency of
application as the printing frequency increases.
If you don't use the printer in the next 48 hours, please pour the remaining resin from the resin
tank back into the resin bottle and seal it well. If there is any residue, please use a filter to filter
it out.
Check the condition of the release film before each printing, and observe whether the release
film is loose, whether there are scratches or severe whitening on the surface, and if so, replace
it in time. The release film is a vulnerable part, please replace it at least once every 1-2 months,
and increase the replacement frequency as the printing frequency increases.
Please be careful when removing the printing platform to prevent damaging the LCD screen.
The service life of the screen is about 2000+ hours and will decrease with increasing printing
frequency. Do a good job of daily screen cleaning, and unplug the machine in time after printing.
If there is a screen exposure problem or service life has seriously affected the print quality, please
replace the screen in time.