Anker Soundcore Sleep A10 SSS - Sayfa 9
Kulaklık Anker Soundcore Sleep A10 için çevrimiçi göz atın veya pdf SSS indirin. Anker Soundcore Sleep A10 12 sayfaları.
Sayfayı Yazdır
A：
You can check whether the earbuds are in sleep mode (you may have touched the left earbud by mistake and
double-tapped to enter sleep mode). In sleep mode, the earbuds can only play white noise, but cannot play Bluetooth
music.
Sound quality
Q：
The sound quality is poor when using them in music mode. What should I do?
A：
You can do the following:
1. Try setting a different EQ via the soundcore app.
2. Reset the earbuds as follows:
Place the earbuds in the charging case and leave the case open. Press and hold the button on the charging case for
10 seconds until the LED indicators on the case flash white 3 times and then flash in sequence. This confirms that
the reset was successful and your earbuds can be connected normally.
3. Try using a different sound source or music app.
Q：
The sound quality of the white noise is poor. What should I do?
A：
1. Update your software to the latest version via the soundcore app;
2. Try using different white noise in the soundcore app.
Q：
The noise cancelling effect of these earbuds is not working well. What should I do?
A：
soundcore Sleep A10 does not support active noise cancelling. If the Smart Volume Control effect isn't up to scratch,
try a different size of ear wings and eartips. Also try to make sure you're wearing them correctly.
Q：
The notification volume is too loud. What should I do?
A：
You can turn off the tone notification in the soundcore app.
Q：
The volume is too low. What should I do?
A：
Volume adjustment is different in the two modes:
1. When using them in sleep mode, the volume of the white noise just can be adjusted via soundcore app.
2. When using them in music mode, you need to turn on volume synchronization via the settings on your mobile phone.