Daikin BRCW901A03 Kurulum Talimatları
Uzaktan Kumanda Daikin BRCW901A03 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Daikin BRCW901A03 1 sayfaları.
Sayfayı Yazdır
CAUTION
1. No switch box or staple is supplied. Prepare them locally.
2. No remote controller cord is supplied. Prepare the optional remote controller cord 4 wire.
3. Be sure to turn off the power to any apparatus connected prior to mounting.
4. Prior to mounting equipment, touch something metallic such as a doorknob to remove static
electricity from your body. Never touch the remote controller board or the adapter board.
5. Keep the wiring away from any other power source lines to avoid electric noise (external noise).
6. Select a flat surface, wherever possible, to mount the remote controller. To prevent deformation
of the cases, do not overtighten the mounting screws.
1. Securing the remote controller lower case
Insert a bladed screwdriver into the concave ( ) in the remote controller lower case to remove the
upper case assembly (two locations).
The remote controller board is located on the
upper case. Take care not to scratch the
board with the screwdriver.
(1) Exposed mounting
Secure the remote controller lower case with the
two supplied wood screws.
(2) Embedded mounting
Secure the remote controller lower case with the
two supplied machine screws.
KJB2121A
(Field supplied parts)
Machine screws (M4 x 16)
For the field supplied switch box,
use optional accessories
KJB1111A or KJB2121A.
Remote Controller Setup Instructions
Upper case
Lower case
Screwdriver
To remove, insert and twist
the screwdriver slightly.
Wood screws (φ3.5mm x 16mm)
KJB1111A
Switch box
2. Securing the remote control adapter
Remove the upper case of the remote control adapter
and secure the lower case assembly.
Wood screws (φ3.5mm x 16mm)
(Mounting with supplied wood screws)
3. Wiring
Remote control adapter (attached)
To indoor unit S21-HA connector
Connector
Tie-band
(to secure the cord)
Attached
five-wire cord
Remote controller cord
(Note 1)
Lower case
Tie-band
(to secure the cord)
Connector
Remote controller
Remote controller
board
board
Upper case
assembly
(Cord drawn out on the back)
(Cord drawn out on the top)
4. Placing the upper case assembly of the remote controller and the upper case of the remote controller adapter back into their original positions
Catch the lower hook first.
During mounting of the remote
controller cord, be careful not to pinch
or otherwise damage the wires.
(Remote controller cord 4 wire)
5. Temperature indication change
To change from Celsius temperature indication to Fahrenheit one
Press and hold down
at the
same time for 5 seconds while the
Celsius temperature is indicated.
← See Operation Manual
Double-face
adhesive tape
(Mounting with supplied double-face adhesive tape)
Using wire cutters, make
a notch for wiring and
then seal the notch to
ensure it is waterproof.
Note 1) Ground the both ends of the shielded wire.
Remote controller cord 4 wire
Item No.
Length
BRCW901A03
Approx. 3m (10ft)
Connector
BRCW901A08
Approx. 8m (26ft)
Tie-band
(to secure the cord)
To remote control adapter
3P202923-2B
M08B097