Beckman Coulter Cytomics FC 500 Kullanıcı Kılavuzu - Sayfa 13
Ölçüm Cihazları Beckman Coulter Cytomics FC 500 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Beckman Coulter Cytomics FC 500 14 sayfaları. With cxp software
Ayrıca Beckman Coulter Cytomics FC 500 için: Başlarken (20 sayfalar)
Sayfayı Yazdır
9. When the cleaning panel is finished, the messages at the bottom of the software
window will read "Awaiting Sample" and "Set Automatic Mode"
10. Remove the bleach and water tubes from the carousel
11. If shutting down instrument, proceed to Shutdown Procedure instructions.
Shutdown Procedure:
(all after-hours users should shut down the instrument after cleaning unless the next
user is in the room)
1. After cleaning, press the Idle mode icon
2. Wait for the instrument to transition into Idle mode. The message at the bottom
of the software screen will read Press Idle Mode button to Initialize
3. Fill the reservoir of each of the two black Cleaning Adapters with distilled water
(about 5mL each)
4. Open the MCL cover and load the Cleaning Adapters into the carousel.
a. Put the Cleaning Adapters into positions 1 and 2 of the carousel
b. Position the filled reservoirs toward the center of the carousel
5. Put the carousel into the MCL and close the MCL cover
6. Ensure that the message at the bottom of the CXP software screen reads Press
Idle Mode button to Initialize. Then, press the Auto-Cleanse icon
7. Wait for the Cleanse cycle to complete.
8. The message Cleanse cycle in progress appears during the cleaning cycle. When
the cleaning cycle is done, the message changes back to Press Idle Mode button to
Initialize.
9. When completed, press the Idle Mode icon
10. Exit the software (either FileExit) or click the large "X" in the corner
11. Turn off the FC500 by double-clicking "FC OFF" on the Desktop
Data Transfer Procedure:
1. After finishing running your samples, close CXP software
2. Double click on the "Micro_cyto workgroup" icon below the tree icon on
the desktop then look for the "Fc500" icon shaped like a computer and
double click on it
3. Go back to the RIMS login computer you initially logged in with, and find the
"Users (FC500)' folder on the lower left hand side of the desktop and double click
4. A login window will appear.
a. The login will be: Fc500/general
b. The password is: four****
5. To upload to the PASS space, open the browser and go to webfiles.psu.edu (other
storage sites can be used like Box or the PASS space). For webfiles, your login
and password will be your PSU ID and password. When you log in, on the left
hand side you'll open the folder called "PASS Personal", then upload your files