anko HSM-706S Kullanıcı Kılavuzu - Sayfa 5

Mutfak Aletleri anko HSM-706S için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. anko HSM-706S 7 sayfaları. Milkshake maker

USE YOUR MILKSHAKE MAKER

1. Make sure the switch at "O" position.

2. Pour milk into the cup. The amount of the milk should be no more than 200ml.

Note: Do not fill milk more than 200mL ("MAX/MILK" mark) and all ingredients for mixing should not

exceed 320mL ("MAX" mark) to prevent the mixture from splashing out during mixing.

3. Add Milkshake powder and sugar (or any other ingredients that you prefer) into the cup.

Note: If adding powder that foams easily, try with a small amount first.

4. Load the cup on the appliance with cup holder and clamp.

5. Connect the power cord plug into a mains power outlet.

6. Press the switch to speed "I" or "II" as you need (max. operating time at a time is 1 minute).

7. Press the switch to "O". Let the Milkshake Maker cool down for approximately 2 minutes before

continuing with stirring.

WARNING! Do not operate the motor continuously for more than 1 minute at a time. Allow the

motor to rest for 2 minutes before continuing.

8. Make sure the switch at "O" after use.

9. Disconnect the plug from mains power after use.

TIPS:

Do not overfill cup beyond markings.

For more volume, use low fat milk as full cream milk does not froth as much as low fat milk.

Ice cream and fruit added will increase the volume of the milkshake.

Cool down the ingredients before use as this will achieve maximum volume.

CLEANING AND STORAGE

CAUTION: Never immerse the appliance in water or other liquids. Never use abrasive cleaners on

any part of the product. Do not place any parts into a dishwasher.

 Clean the milkshake maker after each use.

 Remove the power cord from the power outlet socket and ensure the appliance is thoroughly cooled

before cleaning.

 Clean the appliance with a damp cloth or sponge. Wipe dry with a soft dry cloth.

 Wash the cup in warm, soapy water, then rinse and dry thoroughly.

Tips:

Use a small brush (not included) to remove particles of food lodged underneath the stirrer and cup.

If some leftover particles dry onto the inside of the cup, fill the cup with warm water to MAX mixture

level and install the cup onto the appliance. Operate the appliance for about 20-30 seconds to help

loosen the stuck ingredients. Repeat the above step but use clean tap water. Empty milkshake maker and

dry thoroughly.