anko BL1015-GS Kullanıcı Kılavuzu - Sayfa 9

Blender anko BL1015-GS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. anko BL1015-GS 12 sayfaları.

4. After finish blending, move the jar out of the jar support pad, and then carefully remove the

measuring cup and jar lid, then pour and serve.

CAUTION: The speed dial and power switch must be at "STOP" and "OFF" positions

and the power supply cord must be disconnected from mains power outlet before

removing the jar.

SOUP (HEATING) FUNCTION

IMPORTANT! Never operate the blender without the jar lid in place.

IMPORTANT! Never leave the appliance unattended during use.

IMPORTANT! The soup function is for heating only and does not cook raw food. Food

must be pre-cooked prior to using it in the blender.

1. Place the appliance on the flat horizontal surface and make sure it is not connected to mains

power.

2. Remove the measuring cup and jar lid, and then put the required ingredients into the jar and

fill the jar with appropriate amount of warm water. The amount of mixture must not exceed

1000ml. And then fit the jar lid and measuring cup properly.

3. Connect the appliance to mains power, and then push the power switch to "ON" position.

4. Push the function switch to "Soup" setting and the appliance will start the soup blending and

heating process.

5. After cooking for approximately 6 minutes, turn the speed dial to "STOP" position.

NOTE: The blender can heat soup to approximately 75

C after 6 minutes.