Absolare Phono Stage Kullanıcı Kılavuzu - Sayfa 8

Amplifikatör Absolare Phono Stage için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Absolare Phono Stage 13 sayfaları.

5. Connecting the Cables

AC power input is via a standard IEC inlet socket. Operating voltage must only be

changed by an authorized service agent.

There are four DC power cables connecting the Power Supply and the Signal Stage.

Each DC connection has a different number of pins. The 2-pin cable connects to the

2-pin sockets, the 3-pin cable connects to the 3-pin socket etc. The DC connectors

lock into the corresponding socket with a twisting ring. Connect and lock all four DC

power cables before powering-up the system. Never connect or disconnect any

power cable while the unit is operating. Some of the pins carry high voltages, so it is

important to never touch any Power Supply DC Output sockets while the unit is

operating. Also wait at least 30 seconds before disconnecting any cables after

powering down the unit.

You can connect two separate arms/cartridges to the Signal Stage at the same time.

The selector switch between the inputs selects the active input channel. Ground

point is common for both input channels.

Absolare Phono Stage will be ready to operate 40 seconds after turning on the

power but attain full performance after 15 to 30 minutes.

Signal ground and chassis/power ground is separate inside the Signal Stage and

they are connected by a high pass filter to reduce hum and noise. The ground point

near the inputs is connected to the chassis ground. The outside parts of the RCA

output connectors are connected to signal ground.

There are no adjustments required other than cartridge loading. As you can connect

two separate arms/cartridges to the Signal Stage at the same time, there are

separate loading options for each input. To provide more levels in total and a better

match for each cartridge, load values are not the same between channels. If the

preset levels do not match the desired value exactly, you can install your own load

resistors for each input channel (see section 6.2. for installing custom resistors).

There are five factory-fixed plus one custom load level for each input.

Custom resistors can be accessed via the input tube cover on the back of the unit.

ABSOLARE Phono Stage User Manual 1.2