Anntlent AN-CPL70V Plus Kullanıcı Kılavuzu - Sayfa 2
Genişletici Anntlent AN-CPL70V Plus için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Anntlent AN-CPL70V Plus 11 sayfaları. Cell phone signal booster
Sayfayı Yazdır
With the popularity of mobile communications, people want to make a call anytime, anywhere, so the coverage
requirement of communication network is higher and higher, but the reality is not so, sometimes mobile phone signal is
not very good, you want to make a smooth call, even in some places cell phone cannot dial out. in this cases, cell phone
signal booster can solve this problem in a certain extent.
Features
■ AGC(Automatic Gain Control): When the downlink output signal is too strong or self- oscillated, the uplink and downlink
can automatically reduce the gain and reduce the interference signal
■ Self- Oscillation elimination: The system detects self- Oscillation, first reduces the link gain, then detects the
loop, and finds that the self- oscillation is eliminated, the system returns to normal working state, otherwise, the power
is turned off to prevent interference signal.
■ Inactivity Mode: When no user calls, the device is in standby mode, the uplink power amplifier is switched off, and
the static power is decreased by 30%, so as to achieve the purpose of energy saving.
SAFETY WARNINGS
WARNING:
This equipment should be installed and operated with minimum distance 20cm （8 inches）
between the radiator& your body.
FCC Cautions:
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
2 / 11