DryBell Module 4 M-1 Hızlı Başlangıç Kılavuzu - Sayfa 2

Müzik Pedalı DryBell Module 4 M-1 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DryBell Module 4 M-1 2 sayfaları.

Sayfayı Yazdır
DryBell Musical Electronic Laboratory
SAV
ING
POWER ON SETTINGS
When the pedal is powered on, it will immediately operate with the
selected saved settings.
Every user can define these settings himself, depending on the needs.
For example, if you're using a switching system, then you want your
pedals to be activated when the pedalboard power is turned on.
To save selected settings:
1. Set the desired power up settings
2. Press the ORANGE button and footswitch simutaneously
and hold them for 3 secs to save the pedal power up
settings. ORANGE must be first in the sequence; otherwise
you will simply turn the pedal on or off.
Factory defaults:
When turning on the power, the pedal will be in a buffered bypass.
When you activate the pedal, the ORANGE mode will be active, LOW
END cut enabled, EXPANDER operation disabled and EXPANDER
reaction time will be slow.
INPUT and OUTPUT (
top mounted
The input is on the right and the output on the left side of the pedal.
POWER SUPPLY (no battery, power supply only) 13
We recommend a regulated 9VDC /
included). Maximum allowed power supply voltage is 18 V (must be
regulated). Higher voltages than 9V (18 V max) will
dynamics and internal headroom of
consumption for use with electric guitar is about
connect another device with much higher output than an electric guitar,
we recommend using a power supply with 150mA output. The Module
4 has internal protection against reverse power polarity and
electrostatic discharges.
TECHNICAL SPECIFICATIONS:
Model:
Manufacturer Part Number:
Input impedance (Full Freq. mode):
Input impedance (Orange mode):
Output impedance:
Max input level w/o compressor clipping:
Max output level:
Max buffered bypass level w/o clipping:
Preamp gain (PREAMP knob):
Make-up gain (OUTPUT knob):
External power supply:
Power supply connector type:
Nominal current (with guitar):
Operating temperature range:
Length (w/o jacks):
Width:
Height (w/o knobs):
Weight: (w/o package):
Weight: (with package):
Standard color/finish:
CONTACT:
DryBell Musical Electronic Laboratory
Almet Stubica d.o.o.
Address: Toplička cesta 44,
49240 Donja Stubica, CROATIA
M
jacks)
11,12
minimum
100mA PSU (not
.1
.1
not
affect the tone,
the Module 4.
The current
85
mA
maximum.
M-1
DB2446
900k /1kHz
Dynamic; 80k -200k /1kHz
440 /1kHz
13.0 Vpp / 15.5 dBu
13.0 Vpp / 15.5 dBu
13.5 Vpp / 15.8 dBu
-15 dB (CCW), +11 dB (CW)
-17 dB (CCW), +17 dB (CW)
Adapter 9V DC, (9.0Vmin -
18.1Vmax), 100mA minimum
Barrel, Plug 5.5mm/2.1mm, Center
Negative
~85mA max
-15°C/5°F to 70°C/158°F
122 mm
/ 4.80 inch
73 mm
/ 2.87 inch
40 mm
/ 1.57 inch
0.34 kg
/ 0.75 lb
0.49 kg
/ 1.08 lb
Hippie blue metallic/ Powder
Coating
If you
KNOB SETTINGS
The knob settings shown on a graphic representation above are the
settings of the original Orange Squeezer. The Orange button needs to be
switched on.
Also, those
Module 4's various possibilities.
2 YEAR WARRANTY
DryBell M.E.L. guarantees that this product will work without defects in
materials or craftsmanship, for a period of two (2) years from the date of
purchase. If a defect occurs within the warranty period, it will be
repaired as soon as possible, free of charge. If the product cannot be
repaired and the model is no longer produced, the product will be
replaced with a current model or in agreement with the buyer, with a
similar product. DryBell will extend the warranty period for the duration
of service failure if it is not repaired within 30 days (not including
transportation time). If the original buyer sells the product to a new
owner, the warranty transfers to the new owner. All transportation costs
for the service within the warranty period are paid by the owner of the
goods. This warranty covers manufacturing defects that occurred while
the product was used according to DryBell's recommendations and
instructions. The warranty does not cover loss or theft of products, and
excludes failures caused by misuse, mechanical damage, liquid damage
of any kind, being dropped, unauthorized modification, shock surge in
electricity supply, lightning, improper storage and natural disasters.
DryBell assumes no liability for any damages/injuries resulting from the
use of this product. In using this product, the customer accepts the
terms and conditions set out above. There may be occasional updates
on this product; please visit www.drybell.com to find these.
DryBell
Module 4, User's manual, rev.1.0, 10/2022
settings
are a great starting point to explore the
DryBell Musical Electronic Laboratory.
Doc. No. DM1041 / Page 2
DryBell
is a trademark of