Anolis ArcWash Recessed 136 RGB Kullanıcı Kılavuzu - Sayfa 6
Işık Fikstürü Anolis ArcWash Recessed 136 RGB için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Anolis ArcWash Recessed 136 RGB 19 sayfaları. Rgb
Sayfayı Yazdır4.1 Mounting the fixture
Warning !
Use 2 clamps to mount the fixture on the truss.
Follow the instructions mentioned at the bottom of the base.
Make sure that the device is fixed properly!
Ensure that the structure (truss) to which you are attaching
the fixtures is secure.
The moving-head can be placed directly on the stage floor or rigged in any orientation on a truss without altering its ope-
ration characteristics.
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight for 1 hour
without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This secondary
safety attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges, under high
working places and other endangered areas is forbidden.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture. You must only use
safety ropes with screw-on carabines. Pull the safety-rope through the two apertures on the bottom of the base and over
the trussing system etc. Insert the end in the carabine and tighten the fixation screw.
Fixation via Omega holders
1. Bolt the clamp (1) to the omega holder (4) with M12 bolt and lock nut through the hole in the holder.
2. Fasten the omega holders to the bottom of the base by inserting both quick-lock fasteners (3) into the holes of the
base and tighten fully clockwise.
3. Fasten the safety-rope (2) through the two apertures on the bottom of the base and over the trussing system.
4. Installation
6
1-Clamp
2-Safety-rope
3-Quick-lock fastener
4-Omega holder