Daikin VAM 650GJVE Kullanım Kılavuzu - Sayfa 13

Fan Daikin VAM 650GJVE için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Daikin VAM 650GJVE 18 sayfaları. Total heat exchanger hrv (heat reclaim ventilation)

Sayfayı Yazdır

Example 2:

In case of the remote controller "BRC1A61,62"

Display changes as below.

When air conditioner and HRV

unit are not connected via duct

VRV:

Cooling mode

HRV:

Heat exchange mode

VRV:

Fan mode

HRV:

Heat exchange mode

VRV:

Stopping

HRV:

Heat exchange mode

When air conditioner and HRV

unit are connected via duct

VRV:

Cooling mode

HRV:

Heat exchange mode

VRV:

Fan mode

HRV:

Heat exchange mode

NOTE) Current Ventilation mode doesn't be displayed.

• When the display shows "

qualified service person to clean the filters (Refer to the

chapter "MAINTENANCE").

3-2

PROGRAMMING START AND STOP OF THE

SYSTEM WITH TIMER (Refer to figure 5)

• The timer is operated in the following two ways.

Programming the stop time "

stops operating after the set time has elapsed.

Programming the start time "

starts operating after the set time has elapsed.

• The start and the stop time can be simultaneously pro-

grammed.

Press the timer mode start/stop button "

times and select the mode on the display.

• For setting the timer stop "

• For setting the timer start "

Each time the button is pushed, the indication changes

as shown below.

English

" (time to clean air filter), ask a

". The system

" several

"No indication"

Press the programming time button and set the time for

stopping or starting the system.

Each time this button is pressed, the time

advances or goes backward by 1 hour.

• The timer can be programmed for a maximum of 72 hours.

• Each time when "

" is pushed, the time advances one hour.

Each time when "

" is pushed, the time goes back one hour.

Press the timer on/off button.

The timer setting procedure ends. The display

" or "

constant light.

• After the timer is programmed, the display shows the

remaining time.

For cancelling the timer operation, push the timer on/off

button "

" once again.

The indication disappears.

NOTE

• When setting the timer off and on at the same time,

repeat the above procedure (from "

once again.

DETAIL EXPLANATION

When you want to stop operation after a desired time,

Example:

Set the time to "8".

↓

8hr

" will display.

Stops operation 8 hours after the reservation is complete.

The program will be cleared after the operation stops.

• Set the stop time during operation.

When you want to start operation after a desired time has

elapsed

Example:

Set the time to "8".

↓

8hr

" will display.

Starts operation 8 hours after the reservation is complete.

The reservation is cancelled after operation starts.

• Set the start time while the unit is stopped.

• The remaining time will count at the same time after reser-

vation is complete.

See the example below if you want to reserve "off after time"

and "on after time" at the same time.

For example: (Refer to figure below)

When the timer is programmed to stop the system after 3 hours

and start the system after 4 hours, the system will stop after 3

hours and start 1 hour later.

Example:

" changes from flashing light to

" to "