Dryflow Slimforce Kullanıcı Kılavuzu - Sayfa 8

Kurutucu Dryflow Slimforce için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dryflow Slimforce 12 sayfaları.

MAINTENANCE

Periodic cleaning of the unit is recommended.

Remove cover and clean dryer dust lint.

Wipe the cover with a damp cloth and mild cleaning solution.

Do not soak. Never use abrasives to clean the cover.

DIAGNOSTICS & REMEDIES

Hand dryer fails to

start

Hand dryer turns

on/off erratically

or not sensitive

enough

Not hot air

Hand dryer makes

ticking noise

All of our dryers are designed and manufactured to provide years of dependable performance.

Component parts are guaranteed to be free of defects in material and workmanship for a

period of one (1) year from date of original invoice. This guarantee will be honored provided

that the dryer is installed and maintained in accordance with the instructions. Parts damaged

during the installation are the purchaser's responsibility. The warranty covers defects exclusively,

and only liability for the replacement of defective parts will be accepted. This warranty does not

cover wear and tear, or misuse and abuse. Defective parts must be returned, accompanied by the

serial number, to the point of purchase.

This warranty is granted solely to the original purchaser of the unit and is subject to registration.

Ensure the breaker supplying the dryer is operational. If it is,

disconnect the power and remove the hand dryer cover.

Check all the wire connections to make sure they are well fixed.

Turn on power and if it does not work then replace circuit board.

Turn motor blower several times by hand to see if it is blocked.

Ensure that there is no obstruction on or in front of the infrared

sensor zone. Clean any dirt off the sensor lens.

Try adjusting the sensitivity potentiometer on program board. If

still not working, replace circuit board and sensor board.

Check if the heat element switch is power on.

Check if the heat element was broken. If yes, replace a new one.

Check the motor brush worn condition. Replace them or a new

motor.