DryGuy Circulator DG10 Kullanım Kılavuzu - Sayfa 2

Kurutucu DryGuy Circulator DG10 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DryGuy Circulator DG10 2 sayfaları. Boot & shoe dryer
Ayrıca DryGuy Circulator DG10 için: Kullanım Kılavuzu (4 sayfalar)

Sayfayı Yazdır
GENERAL SAFETY RULES
WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow all instructions listed may result in electric shock, fire and/
or serious personal injury.
SAVE THESE INSTRUCTIONS
AREA OF USE:
Do not operate in explosive atmospheres, such as in the presence of flammable
liquids, gases, or dust.
ELECTRICAL SAFETY
Do not operate in standing water
Do not cut-off or restrict air circulation
Do not expose DryGuy Circulator™ to rain or snow
Use of attachments not recommended or sold by DryGuy Circulator™ may result in a risk
or fire, electric shock, or injury to persons.
To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting unit.
Make sure cord is located so that it will not be stepped on, tripped over, or other-wise
subjected to damage or stress .
An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire, electric shock or electrocution.
Two-wire cords can be used with 2-wire or 3-wire extension cords. Only round jacketed
extension cords should be used and we recommend that they be listed by Underwriters
Laboratories (U.L.). If the extension is to be used outside, the cord must be suitable for
outdoor use. Any cord marked for outdoor use can also be used for indoor use. The letters
"W" or "WA" on the cord jacket indicate that the cord is suitable for outdoor use.
An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety,
and to prevent loss of power and overheating. The smaller the gauge numbers of the wire,
the greater the capacity of the cable; that is, 16 gauge has more capacity than 18 gauge.
When using more than one extension to make up the total length, be sure each extension
contains at leas the minimum wire size.
www.dryguy.net
.

OPERATING INSTRUCTIONS

1.
Plug the DryGuy Circulator™
into any standard 120 Volt 60 Hz electrical household
outlets. With care slide into footwear being attentive not to restrict or block air circulation.
2.
Do not trap, smother, pinch, or suffocate the air circulation into or out of foot- wear
with clothing or any other substance. This may cause overheating.
3.
Do not force the DryGuy Circulator™
as much opening at entrance to footwear as attainable being careful not to restrict or
block air flow by any means.
Helpful Tips:
1.
Make sure not to pinch or otherwise suffocate air circulation when placing unit into
footwear. Loosen laces and pull footwear tongue outward to help open breathing space
whenever possible.
2.
Footwear should be dried after every use to help prevent bacteria and fungus growth the
primary cause of footwear odor. Smaller footwear and garments will dry quicker than
larger items.
3.
Smaller footwear and garments will dry quicker than larger items.
4.
Your energy efficient DryGuy Circulator™ heats to a gentle temperature and using Ther-
mal Convection technology quietly dries wet garments, but it does not generate a forced
air movement. At first you may suspect the unit is not operating properly. We recom-
mend placing the unit into your boot or shoe for a period of 15 to 20 minutes as the heat
will be felt when unit is placed in footwear and in service.
Operation Time:
Drying time varies depending upon extent of moisture as well as temperature and humidity
We recommend a minimum of one hour every time your boots are used.
Maintenance:
Use only a damp cloth to clean the DryGuy Circulator™ . Never let any liquid get inside the
unit; never immerse any part into liquid.
into smaller footwear. The unit will work by Leave