Drytac HOT PRESS HGP360 Kullanıcı Kılavuzu - Sayfa 13
Elektrikli Alet Drytac HOT PRESS HGP360 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Drytac HOT PRESS HGP360 19 sayfaları. Heated glass top vacuum press
Ayrıca Drytac HOT PRESS HGP360 için: Operatör El Kitabı (19 sayfalar)
Sayfayı Yazdır
HOT PRESS USERS MANUAL
P
REPARING YOUR MOUNTING SUBSTRATE
Once you have decided on the most appropriate adhesive/substrate
combination for your application, it is important that you properly
prepare your substrate before coating. Although often overlooked, this
can be the most important step when mounting a print or artwork for
display.
FOAM BOARDS
(E.G. FOME-COR®, ETC.)
The surface of these types of substrates is porous and often contains
particles that can spoil an otherwise perfect mount. Clay-coated
surfaces such as Fome-Cor®, Foam-X® and similar boards should
simply be wiped with a TacCloth™ to remove dust particles.
MAT BOARDS/MILL BOARDS
To prepare mat board or millboard for mounting, use the Anti-Static
Wisk™ brush to remove dust particles and other debris.
HARDBOARD
(E.G. MEDIUM DENSITY FIBERBOARD, MASONITE, ETC.)
To prepare hardboard substrates for mounting, wipe down the
surface with a TacCloth. Should the surface contain irregularities, use
sandpaper to remove them, then wipe the surface with a TacCloth.
Please note: Due to their highly absorbent properties, do not wipe
down the surfaces of any of these substrates (i.e. foam board, mat/
millboard or hardboard) with a moist rag.
Illustration 13A: Using TacCloth to wipe
down foam board.
Tip: It is important that you remove dust
and other debris from your prints prior to
mounting.
13
Mounting