Anova TP4600 Talimatlar ve Kullanım Kılavuzu - Sayfa 7
Elektrikli Alet Anova TP4600 için çevrimiçi göz atın veya pdf Talimatlar ve Kullanım Kılavuzu indirin. Anova TP4600 12 sayfaları. Battery pruning shears
Sayfayı Yazdır
Do not prune branches too far from the tree as this will reduce the health of the plant.
Leave a small stretch of the branch to avoid stressing the plant.
While working with the scissors, keep your hands away from the cutting blades and wear
suitable gloves and protective gear.
Remove diseased shoots and remove dry branches on the plant.
When pruning on a tree, prune each branch separately and do not cut multiple branches at once.
3.3 Battery charging
The battery of a new machine is not fully charged. Before charging, insert the battery into the charger
and insert the plug of the charger into the wall outlet. The "+" of the battery must be inserted into the "+"
of the charger, as shown in the picture on the right. The indicator light on the charger will show green
once it is fully charged. Always use the battery after full charges.
3.4 Special attention
1. Before charging, please turn off the switch; During charging, it is normal to have a slightly warm
charger and batteries.
2. If the batteries are not used for a long time, they should be recharged every 3 months to increase the
service life;
3. New batteries or batteries not used for a long time will reach full capacity after 5 times of charge-
discharge cycles;
4. Please do not charge the batteries repeatedly after several minutes of operation, this may reduce the
working time and efficiency of the batteries.
5. Do not use damaged batteries or disassemble the charger or batteries.
6. Batteries can explode in fire. Never burn batteries.
7. Do not charge batteries outdoors or in humid environments.
8. With the gradual decrease of the electric quantity of the battery, it is normal to reduce the capacity of
the cutting diameter.
9. During the charging process, do not use electric pruning shears.
3.5 Blade sharpening
1. Turn off the scissors with the blade open and remove the battery.2. Both sides of the movable blade
are sharpened using sharpening stone by forming the section angle with the blade;3. After sharpening
the blade, clean it, connect and turn on the scissor, test that it moves correctly and close the blade for
future work.