Anova MG3514 Talimat ve Kullanım Kılavuzu - Sayfa 13

Testere Anova MG3514 için çevrimiçi göz atın veya pdf Talimat ve Kullanım Kılavuzu indirin. Anova MG3514 19 sayfaları.

Cutting of an unsupported log

Saw halfway through, then roll the log and cut from the opposite side.

Cutting a supported log

In area A in the image above, saw from the bottom one-third and finish

sawing from the top. In area B, saw down from the top one-third and finish

sawing from the bottom.

Limbing of a felled tree

First check which way the limb is bent. Next, make a shallow cut on the

compressed side to prevent the limb from tearing. Cut through the tight side.

Be alert to the kickback of a cut limb that is compressed or

resisting pressure.

Pruning

Cut from below, finish from above

Do not use an unstable base or ladder.

Don't overextend.

Do not cut above shoulder height.

Always use both hands to tighten the saw.

The tip bumper should always be attached while using the

chainsaw on the tree trunk. Push the spiked bumper into the trunk

using the rear handle. Push the front handle in the direction of the cutting

line. The spiked bumper must be fixed to follow the guide of the saw if

necessary. Use a spiked bumper when cutting trees and thick branches

can ensure your safety and lower the work force and vibration level.

If there is an obstacle between the cut material and the chainsaw, turn off

the machine. Wait until it stops completely. Wear the safety glove and remove the barrier. If the chain must

be removed, follow the instructions in the installation part of the manual. A test should be carried out after

cleaning and new installation. If vibration or mechanical noise is discovered, please stop use and contact

your dealer.

10. MAINTENANCE

Before cleaning or repairing your machine, make sure it is stopped properly. Disconnect the spark plug to prevent

possible accidental starting. Follow the instructions for regular maintenance, pre-operation procedures, and daily

maintenance routines. Improper maintenance can cause serious damage to the machine.

10.1. air filter

Dust on the filter can be removed with a solution of detergent and warm water. To clean the

dirt on the screens, remove the filter cap and brush on the gasoline. When using compressed

air, blow from the inside.