Daily Youth Q3M Manuel - Sayfa 18
Koşu Bandı Daily Youth Q3M için çevrimiçi göz atın veya pdf Manuel indirin. Daily Youth Q3M 20 sayfaları. Multi-function foldable motorized treadmill
Sayfayı Yazdır4.1 Although all treadmills have been adjusted at exworks, the running belt may become loose after
the treadmill is used for some time. The maintenance is mainly carried out by the user. If the running
belt is too loose, the skidding phenomenon of running belt and drum may occur when you step on the
running belt. But excessive tightness is not good either because it may damage motor, running belt
and drum, increase the running noise of the treadmill, etc. In general condition, it is better to lift the
two sides of running belt 5-6cm away from the running board.
4.2 Judgment method for tightness of running belt
Adjust the treadmill speed to 1.5 km/h, grasp the armrest forcefully with both hands and prevent the
operating of running belt with feet. At this time, if the running belt stops running, the front drum
continues running, but the running belt continues running after being released, indicating that the
running belt is excessively loose. Meanwhile, the user may feel the halt at sometimes, and the
long-term use under the loose state may shorten the service life of running belt. Therefore,
adjustment should be done timely.
4.3 Adjusting method for the tightness of running belt: After the treadmill is used for some time, the
halt may be felt while you are running on it, which is caused by the excessive loose running belt. The
tightening adjustable bolt of the right and left rear regulating box is used to adjust the tightness and
deflection. It is the core component of the adjustment of the complete treadmill.
Adjusting method: (note: the clockwise means tightening and the anticlockwise means loosening. All
the tightening and loosening as shown below stand for clockwise and anticlockwise respectively.)
After the treadmill is used for some time, the running belt may get extended slightly. If you feel the
skidding running bet, it shows the running belt is too loose. Thus, tighten the adjustable bolts of rear
cover at both sides at the same time by 1/4 circle until no skidding or halt is felt while you are running
on the treadmill.
Special attention: As for the running belt, it is not the tighter the better. The tightness should
be adjusted as required. The service life of the running belt may be shortened if it is too tight.
5. Adjustment for deflection of running belt:
As for all treadmills, although the running belt has been adjusted at exworks, the running belt may
suffer the deflection after the treadmill is used for some time. This is attributed to following reasons:
5.1 The treadmill body is placed unevenly.
5.2 While exercising on the treadmill, the user fails to run on the central position of the running belt.
5.3 The strength of user's feet is uneven.
5.4 Adjustment for deflection: It only takes a few minutes to recover artificial deflection by no-load
operation. As for the non-recoverable deflection, the running belt adjusting bolts should be adjusted
with the auxiliary special tools by half a circle. For example, if the deflection is leftward, clockwise
adjust the left adjusting bolts or anticlockwise adjust the right adjusting bolts, and if the deflection is
rightward, clockwise adjust the right adjusting bolts or anticlockwise adjust the left adjusting bolts.
The deflections of running belt are mainly maintained and repaired by the user. As the deflection may
seriously damage the running belt, the deflection should be timely corrected if any.
6. Adjustment for motor belt:
6.1 As for all treadmills, although the motor belt has been adjusted at exworks, the running belt may
suffer the halt after the treadmill is used for some time, because the motor belt gets loose.
6.2 Judgment method for tightness of running belt: adjust the treadmill speed to 1.5 km/h, grasp the
armrest forcefully with both hands and prevent the operating of running belt with feet. If the running
belt stops running, the front drum continues running, but the running belt continues running after
being released, indicating that the running belt is excessively loose. Meanwhile, the user may feel the
halt at sometimes, and the long-term use under the loose state may shorten the service life of running
belt. Therefore, adjustment should be done timely.
6.3 Solution: Use special tools to clockwise adjust the motor belt adjusting bolts for several circles
until the user cannot feel the halt. This adjustment is mainly carried out by the user.
Adjusting method for motor belt: Clockwise adjust the motor belt adjusting bolts by half a circle with
auxiliary tools.
- 18 -